2012 Toyota Yaris Transmission Fluid/Filter Change
HTML-код
- Опубликовано: 27 авг 2024
- Follow us on instagram:
@smdwamc_juanp
@eh2abraham
@david.nieto.1800
@ekdav_
@ef_marco
Free for profit music:
Outro music by Griesgrammar
• [FREE] Bones Type Beat...
J Dilla x Knxwledge Type Beat "432hz" [FREE]
• {SOLD}J Dilla x Knxwle...
FREE FOR PROFIT "Life Changes" J Cole x Mac Miller Harp Type Beat
• *SOLD* "Life Changes" ...
FREE Mac Miller ft J. Cole Type Beat / Heavens Above (Prod. Syndrome)
• Video
Finally! A video on the correct way to change the tranny fluid and filter! Salute!
Great job man! I plan to help my gf with this in a few days. Can i ask what you used to hold the gasket in place on the pan? Thanks.
High Tack Gasket Sealant. It's a brush on stuff that will "glue" or hold on the gasket to the pan. I would personally paint a bit on the top as well before assembly. Me personally now I do the ultimate which is to just use transmission atf gasket maker by permatex on both sides of the gasket to essentially glue and seal it at the same time. Most say that's not supposed to be done but I've had 100% success doing it for years now with no problems. Doing any other method, other than the High Tack, I have had problems periodically - meaning they aren't 100% methods. Anyway, hope that helps.
'07 2nd owner at 140k...Fluid is dark red, no shavings in pan. I normally change every 40k. 1st owner is a friend who bought new and she cant recall if Toyota's stealership service ever changed; I have all the paper records and did not see anything.. I was a bit leery about doing it over 100k [the rule I was taught]. Oddly I had 6qts drain out, drain/fill specs all say 2.5/2.7 and I've seen 3qts total discussed here. So I'm thinking my initial fill should be 2.5 OR should I put back in what came out...guess I should have checked the stick first! It may have been overfilled to begin with.
Hey awesome video! My 2007 Toyota Yaris had 149,xxx miles on it and the fluid still had red tint but was mostly darker then your typical fluid. I changed it along with the filter, dropped the pan, cleaned the pan, and I drove it for about 50 miles before it slipped and now no longer goes forward at all. My fluid was at the right measurements but still seemed to have messed up my transmission sadly. I use valvoline max life on most of my cars and did on this job. I was told by local Toyota shop that Valvoline Max life is an alternative to the Toyota Fluid. Let me know what you think! Thank you.
Was their a lot of metallic material on the bottom of the pan?
Also I would always recommend the toyota type fluid oem
Normal amount of stuff collected by the magnets I’d say. I’ve seen transmission fluid look 10x worse changed it and haven’t had this problem.
@@garettsimon3800 could have been the fluid you used. Valvoline multi vehicle
Use only Toyota WS fluid.
Use gloved bro! Mind ur hands. Respect ur job
I just did mine after drive 20 plus miles . Is it cool changed it out while hot?
Yeah you can do that it shouldn't be a problem. Lots of guys swear by doing that but personally I think it doesn't matter. Cooler means you won't get burned and warmer means you might strip bolts on the pan so I would never replace a pan while hot, just drain and refill maybe while hot. Otherwise always cool.
Do you know where the output speed sensor is located on transmission?
Nice job...any thoughts about disconnecting a line to the oil cooler and blowing the fluid out of it? I did it on my Celica...not sure if this can be done on my Yaris?
My Friend, How many torque the bolts ft pound. 7 to 10 ft pound.
How many miles did your Yaris have when you did this service?
It was my neighbors car but it had well over 200k miles on it
@J D yea, of course, just make sure the car is safe and it can't move while you're under it. Have a second person to help you just in case
@J D look for the pinch welds by where the side squrts are
Nice! I ended up selling my Yaris to up grade to a bigger family car. It had 150k and the oil was still pink! So ended up not doing it before I sold it. One of the best and reliable Toyota model in the line
The washer for the transmission bolt, is that a M12 or M14?
Bro my car is Toyota yaris 2011 model 1.3L and it's 200k+ and I haven't changed the transmission oil yet any advice for me and is it safe now to change? Sure nothing bad will happen if I change it now?
Did it take 3ltrs exactly? I’ve heard it takes about 3.25.
2.6 actually, but whatever. Just put in 2 and then measure with dipstick and add bits at a time and keep checking.
That's the exact same transmission on Ford Fiesta and Mazda 3, made by Aisin Warner
A tip : watch series on Flixzone. Me and my gf have been using it for watching lots of of movies these days.
@Remington Zechariah yup, I've been watching on flixzone for since november myself :)
No it is not. This is the 340, whereas the Fiesta has that new double manual structure auto that constantly fails.
Helpful video! I bought a second hand 2010 Yaris with now has 110,000+ miles. Don't know the maintenance history of the car. Is it too late to change the transmission fluid? Thanks
If the fluid is not black then I would change it
if the fluid is off color, use valvoline high mileage. if the fluid is still redish, use toyota ws. in either case, change the fluid!
Absolutely not. Trans fluid can and should be replaced. Most disagree but in my personal experience dirty fluid gives dirty results and clean fluid gives clean operation. The Yaris in particular shakes like a MFr until you change the fluid. Make sure you use the right stuff.
Is this an automatic? I'm confused on how you only needed 3 quarts after pulling the bottom pan and Channing the filter. The owner's manual for mine says 2.6 US quarts for a simple drain and fill but there's 6.8 US quarts in the trans. So I hope checked your transmission fluid level.
Yea it was about 2.6 US Quarts. I just filled it up until it was at the full mark
yeah that's right, I got my wifes yaris 2008 HB auto transmission parked for 3 days then today I changed the fluid and 3 quarts was not enough, when the car is really cold you need some more than when is hot.
There is a difference between the total amount in the torque converter and whatnot and how much you have to add after just a pan drop. But yeah 2.6 and yes this is an automatic.
thanks for posting, good video with the exception of annoying music and not wearing gloves while handling the toxic transmission oil
I just washed my hands afterwards
LMFAO I thought the same thing, wear some gloves! Just because they SAY it's not toxic doesn't mean it's not!
Nicely done...
Thank you!
thanks for the video dawg!!!
Saludos amigo que modelos es????
Should I be good with 3 quarts
Start with 2 and check dipstick, add little bits from there and keep checking.
Dtc p2763 my problem
2009 HUNDAY TUCSON CHANGER FILTRE À HUILE TRANSMITION VIDÉO SVP
Is it ok to mix up type 4 and ws?
no
As long as it's the toyota stuff or the valvoline multi vehicle you're good.
But yeah don't mix them.
where does those magnets exactly go?
On the bottom of the pan. They collect all the metal shavings in the oil
There are 2 indents in the pan where they go, you kind of can't miss them.
What model is the engine, filter and gearbox?
It is a 1.5 liter engine but I am not sure what kind of filter or gearbox it has. I believe it is a 5-speed automatic gearbox.
@@16thstproductions42 The 1.5l engine comes with the U340E transmission.
Where exactly do the magnets go?
There should be some indentations inside the pan, but if not then just put them on the lowest part of the pan
There are little rectangular indents in the pan for them.
The Toyota Stealerships around me all want $400 and up to do this! ??? I'll always try and do it myself and save my cash. This doesn't look hard at all.
Why not just clean the magnets with a solvent? Use gloves.
True, never thought of that. I usually just use a rag and gas, but thanks!
You just wipe off the excess metal and trans fluid, no need to get all fancy about it. You're cleaning off the metal shavings from trans operation. Hopefully you don't have many. After 100K miles my Yaris had next to zero metal shavings on the magnets. Good stuff!
Hey man had the ATF drain and filled by mechanic, next day after driving for abit and running through the gears, checked the dipstick with engine running on park, fluid level is about 1cm over hot mark.
Should I be worried and drain some fluid? 2014 Yaris.
That's fine
Difficult video to watch. Constant motion because of the head cam.
Yeah I was getting motion sickness watching this.
Most people are thankful he uploaded it
WTF is this? A music video?