HI THÈ OLD MATEY, Well, thistems I think I got one for you. The rattling is indeed the doors, but I found the problem. The magnets on each of the top of the door aren't catching the receiver properly, I placed two spade connectors under each bottom hinge point, and that intern lifted the doors up enough to allow the magnets to mate properly with the receiver. I also drilled the bottom of each aluminium panel and fitted some small self tapping screws, ( it is very important to drill close to the bottom edge of these panels as the screws will slip over the top of the base quite easily. Take note of how close yo the edge the side screws are and try to maintain the same distance. I fitted four screws to the bottom of each panel. Now the one nois hou hear is the fans on the extruder. I almost forgot to mention that I two fitted some very thin foam strips to the receivers and the spad connectors you will need to remove the part that the wire fits in. I just snipped them off at the point where the back rounde off. Hope this helps. All the best. Mike Irish 😊
HI THÈ OLD MATEY, Well, thistems I think I got one for you. The rattling is indeed the doors, but I found the problem. The magnets on each of the top of the door aren't catching the receiver properly, I placed two spade connectors under each bottom hinge point, and that intern lifted the doors up enough to allow the magnets to mate properly with the receiver. I also drilled the bottom of each aluminium panel and fitted some small self tapping screws, ( it is very important to drill close to the bottom edge of these panels as the screws will slip over the top of the base quite easily. Take note of how close yo the edge the side screws are and try to maintain the same distance. I fitted four screws to the bottom of each panel. Now the one nois hou hear is the fans on the extruder. I almost forgot to mention that I two fitted some very thin foam strips to the receivers and the spad connectors you will need to remove the part that the wire fits in. I just snipped them off at the point where the back rounde off.
Hope this helps.
All the best. Mike Irish 😊
No more rattle heard since the self adhesive tape stuff fitted on to the hinge part as in this video. About 4 hours so far