Street able and mfi don’t belong in the same sentence , my dads previous setup in his mustang was a scj headed 460 with a enderle setup on methanol and it was not street friendly at all. We drove it down a1a to bell air plaza during the turkey rod run in Daytona beach about 10 years ago and it burned through 10 gallons of methanol in about 6 miles
@@carsandfirearms2467 that's insane haha, just burning fuel like that is mad! Sounds like good fun though. Yeah the more I've looked in to it and got various blueprints to browse over the more it becomes apparent it's just an on/off setup! Nothing that couldn't be modded to make it streetable though. Although with what's about today it's cheaper and easier to got EFI! Hope you're well bud!
@@chevytech1 never did answer me. Why did it lean out at the end? Was it because of limited amount of fuel for the first test start up for the video or what?
Now that is what a 'Proper' SBC should sound like - wow...
That's epic, is it going to be streetable aswell? If so how do you setup the mechanical injection for that?
This is my question
Street able and mfi don’t belong in the same sentence , my dads previous setup in his mustang was a scj headed 460 with a enderle setup on methanol and it was not street friendly at all. We drove it down a1a to bell air plaza during the turkey rod run in Daytona beach about 10 years ago and it burned through 10 gallons of methanol in about 6 miles
@@carsandfirearms2467 that's insane haha, just burning fuel like that is mad! Sounds like good fun though. Yeah the more I've looked in to it and got various blueprints to browse over the more it becomes apparent it's just an on/off setup! Nothing that couldn't be modded to make it streetable though. Although with what's about today it's cheaper and easier to got EFI! Hope you're well bud!
Sounds fantastic, is it a 383 stroker block? What fuel pumps/system are you running? Thanks!
350 Cubic inch with 12 psi boost. Enderle fuel system with 80A Billet 7.1 GPM
@@chevytech1 that's awesome, it sounds killer!
@@chevytech1 never did answer me. Why did it lean out at the end? Was it because of limited amount of fuel for the first test start up for the video or what?
That’s a beautiful engine !!
How much to build that exact engine, blower combo? I'd like to put that in my 1968 Camaro SS
40grand
Sounds super super good! What does it run in the 1/8th?
Still finishing up some chassis stuff. Haven't made a pass yet .
How about now?
@@fnafplayer6447or now🫣
Why did it lean out towards the end there?
its mechanical fuel injection and the fuel can run off of compression like top fuel.
Now thats sum 2 be scared of
First start up and didn't check timing?
Went from dual carb pump gas to methanol injection .
Niiiiccee
The blower belt is too tight
Thanks for the advise . I usually go for 1/2 inch defection cold .
Very nice. Hope it holds up to that kind of fuel at least a couple of runs. What percentage of methanol to alcohol are you using ??
99.9 percent pure methanol .
methanol IS alcohol lol