I have a B6.4 as well. Was deciding between this and the Xr10 G2S. I have the ota programmer already since I run hobbywing esc in most of my cars. I cant decide which to buy. On one hand I trust hobbywing and their products. They are built good and last a while. ELCeram is new to me and I can't speak for their customer service or quality od their escs. I'm torn tho cause this screen is nice to have for immediate info. My hobbywing ota gives me all this information as well just takes an extra step. Have to plug the programmer in and load the app. Its not that hard nor does it take that long. So I'm torn between these 2 escs lol
Check out the Nitride here: www.amainhobbies.com/elceram-nitride-1-10-brushless-lcd-display-esc-elcnitride110/p1531651
Should make a 1c version for carpet oval class to
Imagine castle did this with a 12s esc. Next level
That’s sick ❤
put this esc in my b6.4
it is money !!!! 🏁🏁🏁
Great, happy you're lovin' it!
-Brett
I have a B6.4 as well. Was deciding between this and the Xr10 G2S. I have the ota programmer already since I run hobbywing esc in most of my cars. I cant decide which to buy. On one hand I trust hobbywing and their products. They are built good and last a while. ELCeram is new to me and I can't speak for their customer service or quality od their escs. I'm torn tho cause this screen is nice to have for immediate info. My hobbywing ota gives me all this information as well just takes an extra step. Have to plug the programmer in and load the app. Its not that hard nor does it take that long. So I'm torn between these 2 escs lol
Can't decide on this esc or the G2S. I already have the hobbywing ota programmer so the programming isn't an issue for me
Peut on conserver les différentes courbes et informations du run en mémoire ?
What’s refresh rate should I set my Rx channel output for this esc?
Setting for drift....?
If motor or batt wires are cut to short or go bad cant replace
how does trapping all the heat at the bottom help cool it off? especially when the heat is created from above???
Thats were the FETs are to make room for the screen
How much 300 dollars I bet
It's under $300 but close to it.
-Brett
👍👍 NOT Made in China!! ❤️