Step-by-Step Guide: Installing a Minn Kota Ulterra Trolling Motor To a Crestliner Sportfish
HTML-код
- Опубликовано: 9 июл 2023
- MKA-32 Quick Release: amzn.to/3PzQKmF
Minn Kota Ulterra: amzn.to/3XrKpf2
Ryobi Drill: amzn.to/3NCCA2E
Sony ZV-1: amzn.to/3QIEKwN
GoPro Used: amzn.to/2NusMv0
DJI Wireless Microphone: amzn.to/3vSrdeh
ULANZI Case w Cold Shoe: amzn.to/3kLXldf
Tripod: amzn.to/3a0oF1u
GoPro Quick Release Mounts: amzn.to/2L2zFTu
GoPro Quick Release Buckle: amzn.to/3ocyp1h
Step by step guide installing a Minn Kota Ulterra to a 2023 Crestliner Sportfish using the MKA-32 quick release bracket.
Watch 1st. Minn Kota Ulterra Quick Release Bracket: How to Mount it to Your Trolling Motor: • Minn Kota Ulterra Quic...
Please don't forget to Subscribe and hit that Like button!
As an Amazon Associate I may earn from qualifying purchases. At no extra cost to you, your purchases help support this channel. Thank you!
#minnkotatrollingmotor #UlterraTrollingMotor #TrollingMotorInstallation 
Хобби
Nice work. You make everything look so easy.
Trying to see how you attach the Ulterra to its base after the base is mounted ted in place! No one shows that!
Check out time stamp 4:36, hopefully this shows what your looking for.
@@DeanoOutDoors
No, no it doesn’t.
Very nice explanation! I'm wanting to do the same but I'm wondering if there is any motion between the bracket and the trolling motor while in use.
I haven’t noticed any motion while running the trolling motor. To me, it operates the same as mounting directly to your bow. I have used both ways in the past. If you never plan on removing the trolling motor for water activities such as tubing etc., then you may not want to install this, but we tube allot so it’s nice to be able to remove the trolling motor in a couple minutes.
@@DeanoOutDoors I'm using this application for sun wear and tear on trolling motor also
I'd use anti seize on stainless bolts and nuts for gulling on trolling motor also I'm putting same setup on my boat
Thanks for the tip!
Can the trolling motor be attached/detached while it is still ‘deployed’ in the vertical position? I’m considering using this quick release bracket on a pontoon boat and would not be able to lay it down in the stowed position. Thanks!
Yes, you should be able to remove it while deployed. Just leave a little extra room on the front while installing so you can slide the motor backwards to detach. It takes roughly one inch of movement backwards to detach.
Great video Deano. Only thing I am looking to verify is let’s say you have a stow issue with ulterra. Seems like it’s an easy process to get it off? Looks like you would lift from the side and wouldnt have to worry about clearance from the shaft pulling it in?
Yes, that’s a good point. If you have a failure on your Ulterra stow, you could easily remove the motor with the quick release saving you a headache in the process 🙂.