when the selector valve fails add another filter so you have a filter from each tank before the selector valve they dont like even finest of silt rust or water from the tanks it kills them fairly quick. hope that helps
Got more info on that Holley pump & how it's setup? I have dual tanks on my truck the selector valve is a 3 port though I'm having the same issue with not enough fuel
Giovanno Galindo sorry it took so long to get back to you it's a holly blue I got it at pepboy Summit Racing carries them I'm also going to add fuel regulator to it to keep it at 9 PSI
i have 75 454 with dual tanks new sending units new switch and new u7001 6 ports we hooked i all up and only one side seemed to work the other showed like bad groundi think we are very close Im not the mechanic ..anyhow i found a video where it says all must loose power for three seconds or voltage goes to zero then you can re-apply power and the gauge switches...have you found or do you know if this has to be so...i dont here you mention it but this video shows an example ruclips.net/video/LnfjP1BO3qU/видео.html
Thanks for explaining everything and showing it up close. Good work!
Thanks for all your help Marcos✊
when the selector valve fails add another filter so you have a filter from each tank before the selector valve they dont like even finest of silt rust or water from the tanks it kills them fairly quick. hope that helps
Got more info on that Holley pump & how it's setup? I have dual tanks on my truck the selector valve is a 3 port though I'm having the same issue with not enough fuel
Giovanno Galindo sorry it took so long to get back to you it's a holly blue I got it at pepboy Summit Racing carries them I'm also going to add fuel regulator to it to keep it at 9 PSI
Who did you email for wiring diagram? Do you still have it?
Don't have it gave it to the new owner of the I emailed Winnebago
Marco I am having issues with this...could you possibly help?
i have 75 454 with dual tanks new sending units new switch and new u7001 6 ports we hooked i all up and only one side seemed to work the other showed like bad groundi think we are very close Im not the mechanic ..anyhow i found a video where it says all must loose power for three seconds or voltage goes to zero then you can re-apply power and the gauge switches...have you found or do you know if this has to be so...i dont here you mention it but this video shows an example ruclips.net/video/LnfjP1BO3qU/видео.html
Yeah those six port I found work like that video.don't work unless you turn off the power I tried two of them so I went with my method
Yes
Gr8 vid