Thanks for the video Adam, fantastic video, clutch is now replaced, and all ok. You are right about the gasket, a right pain in the ar…. All of he best
I'm very mechanically inclined. This video made my job super easy. I was able to run through this job after seeing what all needed removed to get to the cover properly. Also I had all the proper o rings and gaskets ready for the job.
Dude keep up the videos on the st1300 I've been curious with how these things are done and I've seen more of yours about the st then anyone else! 👍very pleased
Hey Adam, enjoy the videos on the ST. Very helpful and entertaining. Says you are in Phoenix. I just bought an ST and live in Prescott. Hopefully see ya sometime on the fine AZ roads.
I have an 06 and the clutch keeps hydraulicly locking and I have issues shifting when stationary and it creeps forward when I pull the clutch lever in. Can you please give me a list of all the parts and gaskets used to redo the clutch... Thanks
Thanks lots of good information but it would be better if you included some video of the cover and case goo and removal as well as the actual placing of the plates. Good stuff... Im off to your next video
Good video. Where did you tap and pry gently to get the front cover off? I tried tapping with a rubber hammer with no success and not real comfortable using a screwdriver to pry it. If I have to I will. Thanks EDIT....used a wooden dowel. There is a tab on the left lower side of the case. Then used a tiny flat screwdriver to pop the upper section. Going to use 84 inch lbs/ 7ft lbs as torque.
Thanks for the video Adam, fantastic video, clutch is now replaced, and all ok. You are right about the gasket, a right pain in the ar….
All of he best
I'm very mechanically inclined. This video made my job super easy. I was able to run through this job after seeing what all needed removed to get to the cover properly. Also I had all the proper o rings and gaskets ready for the job.
Dude keep up the videos on the st1300 I've been curious with how these things are done and I've seen more of yours about the st then anyone else! 👍very pleased
Hey Adam, enjoy the videos on the ST. Very helpful and entertaining. Says you are in Phoenix. I just bought an ST and live in Prescott. Hopefully see ya sometime on the fine AZ roads.
Thanks for the info.
I have an 06 and the clutch keeps hydraulicly locking and I have issues shifting when stationary and it creeps forward when I pull the clutch lever in. Can you please give me a list of all the parts and gaskets used to redo the clutch... Thanks
Thanks lots of good information but it would be better if you included some video of the cover and case goo and removal as well as the actual placing of the plates. Good stuff... Im off to your next video
Good video. Where did you tap and pry gently to get the front cover off? I tried tapping with a rubber hammer with no success and not real comfortable using a screwdriver to pry it. If I have to I will. Thanks
EDIT....used a wooden dowel. There is a tab on the left lower side of the case. Then used a tiny flat screwdriver to pop the upper section. Going to use 84 inch lbs/ 7ft lbs as torque.
Any one knows the dowel pin o ring part #?
How many miles on the bike?