how about a brass bushing on the inter bolt to goe bolt diameter closer to slide size in door card, may helb to hold up bolt or install door card a little higher to support bolt
I don’t remember if I removed the handle or not but I’d be looking to drive it out from the top or bottom. Got another busted handle here so it’ll be on my todo list again at some point.
cool idea of the plastic inside door trim keep recording!
Nice old reliable lathe.
Where are your door alignment pins?
How do you get the key piece out to get it re-keyed
I already had the key but if you take it to a locksmith they can probably rekey it for you.
how about a brass bushing on the inter bolt to goe bolt diameter closer to slide size in door card, may helb to hold up bolt or install door card a little higher to support bolt
Hi, I'm trying to replace the handle on my L300 and I can't figure out how to remove the pin that holds it in place. Any ideas?
I don’t remember if I removed the handle or not but I’d be looking to drive it out from the top or bottom. Got another busted handle here so it’ll be on my todo list again at some point.
maybe leave a drip hole in bottom of caulk layer
What kind of solvent did you use to clean it?
Probably just good old stoddard solvent like you’d use in a parts washer