BROKEN WEAPONS LIGHT PRESSURE SWITCH? NO PROBLEM!

Here is my first attempt at fixing a broken pressure switch on camera. It's a cheap light in general, and this channel is pretty much based on saving money, so a good repair was in order.

[@wwolterink]

Worked like a charm! Thanks for sharing

[@stevequate1797]

Know you don’t read these posts anymore being so old but wished someone would do a video on how to wire a pressure pad(two wire) into power tail end of a flashlight. I hv small adjustable flashlight perfect for a AR15 flashlight power on/off end cap light, gutted end of cap, punched hole in rubber button on end of light, ran wires thru hole soldered one wire to spring, thought other end would ground out while screwing end cap back on but light stays on I made one of these lights about 10 years ago but Damn forgot how I did it

[@joshleduc1771]

Liquid electrical tape would probably been good for where the heat shrink didn't fit to.

[@thereloadingroom433]

I didn't think of that! I'll give that a shot :) Thanks!

[@kanadakb8690]

is it possible to buy just the actual switch without the cable on amazon ?

[@Ty-tie_FTW]

I bought a genesis onyx light like 3 years ago, since i took it out of its tight ass packaging, the remote switch is stuck in the on position. I paid like 100 bucks for the light, but nobody can give info on the lifetime warranty. Could this videos problem possibly be my problem also?

[@darkstar-singularity]

I take it the white is the negative or is that the positive from the flashlight looping back to the switch and returning as the red positive back to the flashlight?