Replace Heater and Thermistor for the Hot End PRUSA XL

The heater and Thermistor That heat and monitor the hot end of an extruder can fail and then you can't print your literally dead in the water. These can fail unexpectedly and you really should have a backup unit for these. A link is below where to get those. Step-by-step directions on how to replace these two items is carefully gone through so that it will be easy for you to make this change.
Get the Hot End Part Nextruder - Heater 100K Thermistor: amzn.to/3yrrRmQ
Click here to order Original Prusa XL:
www.prusa3d.co...
TECKMAN 11 in 1 Torx Screwdriver Set :
amzn.to/3UMPtvh
* please be advised that the above link is an affiliate link, and I do receive a small commission if you make a purchase which helps support videos like these
As a retired plastic surgeon, I explore many areas of my current interests including repair, restoration, wood working, metal working, tool review, hunting, traveling, and farming. Please join me on my journeys through these different areas of interest.
#DIY #doityourself #howto #TheMoreYouKnow #Teach #Learn #DrJoe #problemfixed #problemfix #problemfixer

[@petej1940]

Thanks for the link to the hot end - it saves the cost and time of ordering the part from Prusa.

[@JosephHunstad]

Hey, you are so welcome. Yes why not save some money instead of having to buy directly from Prusa. Thanks for your comment. Consider subscribing. Thanks. Joe.