Well done sir, you covered all the basic steps for the use of this tool, I just learned from another video that, you can actually limit the travel or the "pull" distance to 3mm to 3.5mm (1/8") max, this is important for smaller mandrels like M3 and 8-32" since they do not need a lot of leverage to crush an M3(8-32") nut , any more than 3mm pull may be excessive and can easily snap the smaller mandrels. best of luck.
l'd Luke to see that other video. I tried to figure it out from the "instruction manual", but cannot. Can you provide a link to the video that shows how?
Well done sir, you covered all the basic steps for the use of this tool, I just learned from another video that, you can actually limit the travel or the "pull" distance to 3mm to 3.5mm (1/8") max, this is important for smaller mandrels like M3 and 8-32" since they do not need a lot of leverage to crush an M3(8-32") nut , any more than 3mm pull may be excessive and can easily snap the smaller mandrels. best of luck.
l'd Luke to see that other video. I tried to figure it out from the "instruction manual", but cannot. Can you provide a link to the video that shows how?
Your hair is shinier than most hair product commercial models I've seen!!
Repair shop guys>😃👍
Fructis shampoo\conditioner ceo>😃👍
Thank you
Are the mandrels long enough to use Plus-Nuts ?
Not with the main collar on but if you remove the main collar, you may be able to use plusnuts.
Can you make your meter go up to 10mm?
IT CAN WORK ON M10 rivet nut