I'm surprised you used a press on those pins, there is an easier way. I also didn't notice if you used the main bearing shell retaining pins, video flashed past that bit. Thanks for sharing.
I'm honestly surprised no one has made any comments here regarding your build. Its been a few months since you put it out and it just made my feed for the first time. It looks fine so far. Mind you im sure you'll face a lot of critics but that's to be expected. My only suggestion is your music score. Seems like I'm watching the goonsquad boys on one of their videos. Regardless keep up the work.
What manual did you use for this project? My 54cj 3B finally died and needs a rebuild. The shops around here want $3,500-$4,000 to do it. That seems pretty steep for a simple engine.
Eric from that 70’s show is rebuilding a jeep? Awesome!!
I'm surprised you used a press on those pins, there is an easier way. I also didn't notice if you used the main bearing shell retaining pins, video flashed past that bit. Thanks for sharing.
Nice lessons .I enjoy brother
Handsome mechanic
I'm honestly surprised no one has made any comments here regarding your build. Its been a few months since you put it out and it just made my feed for the first time. It looks fine so far. Mind you im sure you'll face a lot of critics but that's to be expected. My only suggestion is your music score. Seems like I'm watching the goonsquad boys on one of their videos. Regardless keep up the work.
This is great stuff.
Where are you located?
I hope that you used assembly lube on those new bearings!
What manual did you use for this project? My 54cj 3B finally died and needs a rebuild. The shops around here want $3,500-$4,000 to do it. That seems pretty steep for a simple engine.
If you broke the timing gear you did not successfully remove it...
Doing it without proper machining is like taking a shower and putting on dirty underwear. Too bad the owner is going Micky Mouse.