i thought you had show cased a unicycle once. and that would have helped with the balance. i could not find the video, guess i was wrong. but bigger is always better. if you had used a parking lot, i feel you could have mastered the skate bike. will watch for the new build.
If leaning back or putting more weight on the rear goose neck seat post may help right? one would think. I think it can be done and improved for sure moving the center of gravity more towards the rear wheel I am unsure about breaking but know some motor skateboards have hand controls I would guess you could rig up a handgrip over a short pipe for a hand break with an average length break cable if the read break is a must and the vertical tube seems in that design does lean forward I assume by design one could set it back a few more degrees to bring it back to an almost vertical or a bit towards the back but just my idea's I am just a laymen and am sure an engineer would be better at a design but if someone was really skilled at CAD could toss something with a tweak or two like described maybe worth a look.
you have to get your hands out more and maybe even use a wall like in the video to under stand the balance point also those trucks are too loose. i as well have the same skate bike but blue wheels.
We need another skate bike!!
You got my approval Jason go for it I'd like to see it 👍
Absolutely make it!!!! 💪💪💪
yes go for it
Youre definitely going to need to visit your bros shop to build the bigger one.
i thought you had show cased a unicycle once. and that would have helped with the balance. i could not find the video, guess i was wrong. but bigger is always better.
if you had used a parking lot, i feel you could have mastered the skate bike. will watch for the new build.
Guess I’ve been under a rock my whole almost 50 years of life. I’ve never heard of or seen one of these before.
If leaning back or putting more weight on the rear goose neck seat post may help right? one would think. I think it can be done and improved for sure moving the center of gravity more towards the rear wheel I am unsure about breaking but know some motor skateboards have hand controls I would guess you could rig up a handgrip over a short pipe for a hand break with an average length break cable if the read break is a must and the vertical tube seems in that design does lean forward I assume by design one could set it back a few more degrees to bring it back to an almost vertical or a bit towards the back but just my idea's I am just a laymen and am sure an engineer would be better at a design but if someone was really skilled at CAD could toss something with a tweak or two like described maybe worth a look.
Could you swap to a wider truck and stiffer bushings?
Wider truck yes. Stiffer bushings no. These are the stiffest bushings. Thanks for watching.👍
👋👋👋Backatcha💯💯💯
make its out of a vintage 26 inch mountain bike!
If I remember right, the front truck has to be very tight.
It's really tight.
you have to get your hands out more and maybe even use a wall like in the video to under stand the balance point also those trucks are too loose. i as well have the same skate bike but blue wheels.
Cool yet unridible.
Some mutants are an evolutionary dead end ... 🙃
Do it
No don't waste your time on a bigger skate bike.