How did you print it I have a creality ender 3 and the limbs just suck I only have PLA filament and have printed both the armor and skeleton in 125% and 0.15 mm layer height any tips?
Hi there! I use a Bambu A1 3D printer with a 0.2 mm nozzle and 0.1 mm layer height. For your Ender 3, try using the same nozzle and layer height and slow down your print speed to 40-60 mm/s. I hope it will work
@@aspeed3dtoys hi it's me again just wondering the nozzle that comes with the ender 3 is a 4mm right I might be wrong but if not what is the layer height for it?
@@averynielson-is9km Hi there! The Ender 3 default size nozzle is 0.4mm. However, it also supports other sizes like 0.2mm. For a 0.4mm nozzle as advised by Dummy's 13 creator: a First layer 0.2 mm Other layers 0.15 mm you can find Recommended print settings here: www.printables.com/model/593185-dummy-13-printable-jointed-figure-beta-files I Hope it will help
@@aspeed3dtoysI tried it and it was worse I used the same settings you suggested and the limbs don't fit together they are too big should I size it up?
Hi again 😊😊
Hi 🙂
I hate how this person have being doing videos since five months and only has 184 subcribers i suscibed and liked if that helped
Thank you so much for your support! It means a lot to me. I'll keep working hard to create content you enjoy! 🙂
@@aspeed3dtoys thx and u have a amazing content
How did you print it I have a creality ender 3 and the limbs just suck I only have PLA filament and have printed both the armor and skeleton in 125% and 0.15 mm layer height any tips?
Hi there! I use a Bambu A1 3D printer with a 0.2 mm nozzle and 0.1 mm layer height. For your Ender 3, try using the same nozzle and layer height and slow down your print speed to 40-60 mm/s. I hope it will work
@@aspeed3dtoys thanks por the advice I'll definitely try it. I just subbed
@@aspeed3dtoys hi it's me again just wondering the nozzle that comes with the ender 3 is a 4mm right I might be wrong but if not what is the layer height for it?
@@averynielson-is9km Hi there! The Ender 3 default size nozzle is 0.4mm. However, it also supports other sizes like 0.2mm.
For a 0.4mm nozzle as advised by Dummy's 13 creator:
a First layer 0.2 mm
Other layers 0.15 mm
you can find Recommended print settings here:
www.printables.com/model/593185-dummy-13-printable-jointed-figure-beta-files
I Hope it will help
@@aspeed3dtoysI tried it and it was worse I used the same settings you suggested and the limbs don't fit together they are too big should I size it up?