#14 How to undo Overlapping Vectors the super easy way done

#14 How to undo Overlapping Vectors the super easy way done
In this video I show a quick solution for correcting overlapping Vectors
Check out Carveco software with the link below.
Carveco link
carv.eco/3IkbxWz
@OnefinityCNC
PWNCNC link
Https://pwncnc.com/?ref=D7STa4Rxeaj8P

[@BuckysCustoms]

hard to see the difference in colors so this is a perfect way to get it done! thanks Vernon!

[@Hinkleshop]

You’re Welcome

[@michaellevine6019]

That's a good one Vernon.....

[@Hinkleshop]

Thank you! Glad you enjoyed it

[@howlinmad4208]

Thanks mate, one for the algorithm 😊

[@Hinkleshop]

Thank you

[@davejsullivan]

Smart and simple.

[@Hinkleshop]

Thank you

[@jimpalmer1944]

Vernon, I am trying to figure a way to save all these quickies in a file. Then when I have a problem, I just refer to one of your video for a solution.

[@Hinkleshop]

I’m sure you are aware but if not,
I have them all in a playlist on the channel
If that helps

[@jimpalmer1944]

@@Hinkleshop Sure, just thinking of a shortcut. BTW, I finally was able to create stacked text following your video. Getting ready to start a new project and will review some of your past tutorials.

[@Checkitfirst]

I have overlapping vectors, but no duplicates how do I get rid of that?

[@Hinkleshop]

Zoom way way in and you should be able to see them and delete

[@Checkitfirst]

@@Hinkleshop there not there. If I delete then all goes away

[@Hinkleshop]

That’s a tough one without seeing the vector because duplication is different than overlapping
If you can I would ungroup the vectors and activate them separately checking with the vector doctor to narrow down the search for the overlap
After isolation I would zoom in on each circle ⭕️ as far as the software will allow you should be able to see them