Cricut - Slice Layering Iron On

#cricut #htv #layering
Following on with our slice layering we look at how to use the technique with Iron On
Slice Layering in Design Space - • Cricut Design Space - ...
Slice Layering Vinyl - • Cricut Slice Layering ...
Design - bit.ly/3wgcg5d
💜Product links below 💜
Cricut UK - cricut-emea.pxf.io/UKShop
DISCOUNT CODE - CRIFTY
10% off & Free Shipping over £50 - Mchines and Press Excluded. Add an extra 10% off automatically by being a Cricut Access Member
Join Cricut Access - cricut-emea.pxf.io/Access
Cricut.com - cricut.pxf.io/USASHOP
DISCOUNT CODE - CRIFTY22
10% off & Free Shipping over $50
Machines and Easy Press Excluded. Add an extra 10% off automatically by being a Cricut Access Member
Please Subscribe, its free to do so and will help me to grow the channel considerably. Don't forget to turn on the little notification bell on so you get alerted every time I upload a new tutorial.💛
💖Please Follow me on Social Media💖
Facebook Page - / criftycrafty.co.uk
Instagram - / crifty_crafty_tutorials
Blog - www.criftycrafty.com
Facebook Group - groups/1514883695243716
I only use products I am happy to recommend in these videos. They are products I love. I am not paid to create any videos on this channel. I receive no funds for recommendations and all opinions are my own. I am sometimes sent free products but I will only use the product in a video if I choose too because I think its worth knowing about.💙
Thank You for purchasing through my links, they may get me a small commission, with out any extra cost to you. This all goes back into products for the channel and for giveaways. Your support is greatly appreciated.
Please note, I craft for personal use, if you craft for Profit or payment it is your responsibility to ensure you have a commercial licence for all the components you use to create your products and are not using copyright materials
All my Tutorials and Videos are on a personal use only basis

[@minawhite]

Very good video as always. Have you ever had to deal with gaps between the layers? I had that problem many times with the slicing method, to the point that I started layering on top of each material when possible. Can the pulling be the cause of it because it actually moves the material?

[@alisongallagher3590]

I think sometimes it you have too high a heat, or press for too long, the vinyl can actually shrink slightly. The only way I have managed to get round this in some instances, is for the outline, use the new offset feature in design space, but 'inset' by a very small amount, just to make the outline slightly thicker. Hope that makes sense. Additionally, for each layer, I don't press for the full time, only long enough for it to transfer. I give it the full time once all the layers are in place and carrier sheet removed

[@minawhite]

@@alisongallagher3590 I'll try the offset solution, and also my pressure. Although I press for less time when I layer, the truth is I do press it quite a bit, so shrinking is possible! Thank you so much for your answer 😊

[@CriftyCrafty]

It can happen a lot with multiple layers because the layers can shrink. I’m filming a video this week in it but as said above I reduce the press time. I normally do it for over 4/5 layers

[@annesanders9629]

I made it but put the Mooody above the cow 😂

[@annesanders9629]

I’m going to make this, love it