FordLogan Corner Post Connections Installation Instructions

Welcome to the FordLogan woven wire mesh installation video on corner posts. This video is for the connection of panels at a 90-degree angle. Begin with a four-way post and a base plate with a single anchor point.
In Step 1, place a woven wire mesh panel on any side of the FWP and bolt using ¼” x 2-3/4” carriage bolts. Then finger-tighten with ¼” hex nuts. For a 8’ post you will need 6 connections. However, every connection should be staggered alternating directions. Note: If you do not skip the holes, the 2nd panel will not assemble correctly.
In Step 2, place the 2nd wire mesh panel to the left of the 1st panel, making a 90-degree angle on the FWP.
As in step1, bolt the 2nd wire panel to the FWP but utilizing the skipped holes.
After all, the panels have been assembled, tighten each hex nut with a 7/16” wrench. Also, if anchoring is required, secure the base plate with 3/8” anchors.
This concludes the FordLogan woven wire mesh partition installation video on corner posts. If you have any questions, please contact us at 812.523.3044. Thank you!