Nice, just enough lift and nice wheels as well. Also in Ontario here, round what, 2? 3? 4? Of the Bs and kids not back in school yet again lol! Fun times! My 21’ Classic is due to go into the shop within a week for the ReadyLift 4” lift with Bilstein rear shocks, 20x9 +1 Fuel Assault with Toyo Open Country AT3 in 35x12.5 so hoping it also turns out nice. Will be lifted just enough that I hopefully will clear the garage door by about 1.5” hahaha! Wish me luck!
Nice. thanks for the video. I've got the 4x4 offroad option that comes with a 1" stock strut lift. I'm planning to do a 2" level kit, with the top strut mount spacer and upper control arm. That should put me at about a 3" total lift in the front and a 1" in the back. Probably just a little less than what you have. The nice thing is the struts on the 4x4 offroad is I have at least 3-4 inches of increase extension. (I found out the hard way when I got a flat and the jack wouldn't get the wheel off the ground in MN in December.) Should give me that extra extension I need to keep from bottoming out the shocks. I don't like too much stick out either. I'd probably toss some fender flares on there if it were me to keep the rocks off the paint. Looks great!
sick! I have my lift being installed now but no tires yet. Like the look of yours alot. I might go less agressive on the tire tho since I drive it on the highway alot
I got my 3.5 ready lift on the way. Got 35 inch tires too but I went with a flush fit rim. I had a 2004 1500 that I went with the aggressive look tires sticking out and hated it lol. But yours is much less aggressive then mine was and looks clean man.
Whats crazy is I have the same set up 35 20x10 arkon on nitto grapplers and they rub so bad I had to trim a ton of plastic on both sides of the front wheels
How much harsher is the ride? I've been contemplating this kit or the 2" Readylift level. I don't want to harsh up the ride too much, the advantage of the 2" level is that it isn't a spring spacer but a strut spacer so the ride remains the same because it doesn't preload the stock springs. But I wish it was a little higher, and the only way to get that at this price point is also adding a spring spacer.
looks great, looking for a tire and wheel combo for my 20 rebel here in Nova Scotia. I figured with the 3.50 lift you wouldn't have to do any trimming.
Looks perfect! I just traded my 13 Laramie w/6" lift in on a brand new Longhorn! I've had 2 boys since lifting my Laramie almost 7 years ago so thinking going the more "family friendly" route this time around and I'm thinking this 3.5" ready lift would be perfect! My truck has the auto running boards that fold out so id be set there for the little dudes climbing up in the back! ...What exact wheel are you running here? I love the look of them and think they would look really good on my metallic billet silver
I have this EXACT setup on my truck. Just got a 2020 Ram 1500 back in May and put a 3.5" ready lift on with 35x12.5 Ridge Grapplers on 20x9 rims. Thinking about going to a 6" lift. Nice truck btw
I just put the same 3.5 ready lift kit on my Ram 2020 bighorn went with the nitto ridge grapplers 35in x 12.5 inch wide tires and I get rubbing when I turn any tips on how to fix this issue
@@519Offroad thanks it worked out just wanted to ask I feel like my kit after it settled in that the back sits lower then it did when I got the kit installed
She's a beauty. I just picked up a warlock and I can't seem to find anyone advertising readylift lift kits. I'm in Ontario as well. Where did you get the lift??
Very nice truck wanted to know how do you like the ride now that you have had it for some time. I’m in the fence i hear good things about it and some bad saying preload spacers make it ride rough. Not sure if I should get rough country 3.5 strut lift.
MT tires are NOT good in snow Mr Neighbor to my north. In MN we have to run AT or Hybrid minimum. Also, billet aluminum welds to steel especially in salt and poly bushings suck in cold too.. Good luck years down the road hopefully it works out.. Nice truck though! I have a 2019 and looking for ideas.
Looks good, I don't like skinny walls either. Thinking to get a truck and have a set similar to what you have maybe little wider. Are you hinking to put on the fender flares? Cheers!
Just Sub'd. Sweet lookin truck! Has a good stance to it. They definitely ride more stiff after a level lift but so worth the look! I prefer the leveled look over lifted any day! I just uploaded a vid of my '14 Bighorn with home built level lift and 35's. Check it out on my channel
Nice, just enough lift and nice wheels as well. Also in Ontario here, round what, 2? 3? 4? Of the Bs and kids not back in school yet again lol! Fun times! My 21’ Classic is due to go into the shop within a week for the ReadyLift 4” lift with Bilstein rear shocks, 20x9 +1 Fuel Assault with Toyo Open Country AT3 in 35x12.5 so hoping it also turns out nice. Will be lifted just enough that I hopefully will clear the garage door by about 1.5” hahaha! Wish me luck!
Nice. thanks for the video. I've got the 4x4 offroad option that comes with a 1" stock strut lift.
I'm planning to do a 2" level kit, with the top strut mount spacer and upper control arm.
That should put me at about a 3" total lift in the front and a 1" in the back. Probably just a little less than what you have.
The nice thing is the struts on the 4x4 offroad is I have at least 3-4 inches of increase extension.
(I found out the hard way when I got a flat and the jack wouldn't get the wheel off the ground in MN in December.)
Should give me that extra extension I need to keep from bottoming out the shocks.
I don't like too much stick out either. I'd probably toss some fender flares on there if it were me to keep the rocks off the paint.
Looks great!
sick! I have my lift being installed now but no tires yet. Like the look of yours alot. I might go less agressive on the tire tho since I drive it on the highway alot
Looks great Kenny. I have a 2020 RAM 1500 BigHorn and I'm getting some ideas and yours looks very nice.
I got my 3.5 ready lift on the way. Got 35 inch tires too but I went with a flush fit rim. I had a 2004 1500 that I went with the aggressive look tires sticking out and hated it lol. But yours is much less aggressive then mine was and looks clean man.
Looks great
Whats crazy is I have the same set up 35 20x10 arkon on nitto grapplers and they rub so bad I had to trim a ton of plastic on both sides of the front wheels
What's your Axle ratio.... 3.21 - 3.55 - 3.92. ?
hi thanks for the video im in Ontario too !!! looking to do lift + tires on my truck atm
Do you have any measurements from the ground to the wheel well
Looks great I wouldn’t go any higher than that. I put a 40 series flowmaster on my ram and it sounds great 👍
How much harsher is the ride? I've been contemplating this kit or the 2" Readylift level. I don't want to harsh up the ride too much, the advantage of the 2" level is that it isn't a spring spacer but a strut spacer so the ride remains the same because it doesn't preload the stock springs. But I wish it was a little higher, and the only way to get that at this price point is also adding a spring spacer.
Looks great 👍
Hey i did the same set up but but my truck shakes a lil bit and it’s weird do u knw why does that after lifting and putting new wheels and tires
Can u help me on how u did the no scrub..have same setup but have that same rubbing
had to tie back some of the plastic
Looks great! How are the axle boots, super stretched?
very nice man
Beautiful truck man.
looks great, looking for a tire and wheel combo for my 20 rebel here in Nova Scotia. I figured with the 3.50 lift you wouldn't have to do any trimming.
I got 2.5 moto fab and that rubs on same truck
@@misaelcarrillo833 who cares
Looks awesome
Looks perfect! I just traded my 13 Laramie w/6" lift in on a brand new Longhorn! I've had 2 boys since lifting my Laramie almost 7 years ago so thinking going the more "family friendly" route this time around and I'm thinking this 3.5" ready lift would be perfect! My truck has the auto running boards that fold out so id be set there for the little dudes climbing up in the back! ...What exact wheel are you running here? I love the look of them and think they would look really good on my metallic billet silver
Contemplating on ready lift 3.5 or rough Country what do you think?
I have this EXACT setup on my truck. Just got a 2020 Ram 1500 back in May and put a 3.5" ready lift on with 35x12.5 Ridge Grapplers on 20x9 rims. Thinking about going to a 6" lift. Nice truck btw
Hey man do your 20x9 wheels and 35s rub?
@@stevengarcia4031 yeah just a little. I can't make a full U-turn so I plan on going to a 6" lift
@@itoldyouso2137 Whats the offset on your wheels?....or would a little spacer fix the rubbing issue?
@@DirtNassty +1
You want to sell the 3.5 lift if you go to the 6"
I just put the same 3.5 ready lift kit on my Ram 2020 bighorn went with the nitto ridge grapplers 35in x 12.5 inch wide tires and I get rubbing when I turn any tips on how to fix this issue
trim a bit of plastic and zip tie inner well back
@@519Offroad thanks it worked out just wanted to ask I feel like my kit after it settled in that the back sits lower then it did when I got the kit installed
Beautiful truck👌🏾
She's a beauty. I just picked up a warlock and I can't seem to find anyone advertising readylift lift kits. I'm in Ontario as well. Where did you get the lift??
Ready lift
If your in the Hamilton area i just got mine from AutoFX
What is your ride height after the lift to the top of the wheel well?
How much was the kit
You have the long bed , correct? 6’4”
Looks nice
How much miles u run per gal on gas
was getting around 15 normal and 7 towing
How many miles u run per gal with tires and wheels what’s the difference
Very nice truck wanted to know how do you like the ride now that you have had it for some time. I’m in the fence i hear good things about it and some bad saying preload spacers make it ride rough. Not sure if I should get rough country 3.5 strut lift.
rides horrible now
MT tires are NOT good in snow Mr Neighbor to my north. In MN we have to run AT or Hybrid minimum. Also, billet aluminum welds to steel especially in salt and poly bushings suck in cold too.. Good luck years down the road hopefully it works out.. Nice truck though! I have a 2019 and looking for ideas.
That’s a great setup and just looks awesome 👍🏼 How’s the ride now? Feel more difference from stock, more stiff?
Do ur tires rub when u put the 35/12.5/20
20x10-25
trimmed very little plastic and was good
That’s good nothing at all when u do a full turn
Because i wanna do the same thing u got on my 2020 Ram 1500 Big Horn
Looks good, I don't like skinny walls either. Thinking to get a truck and have a set similar to what you have maybe little wider.
Are you hinking to put on the fender flares?
Cheers!
Are those oem front guards?
Is this the warlock?
I just bought same exact truck Color too
How does it Drive if I may ask. Does it drive ok and is it super stiff
rides like crap now
@@519Offroad Really are u serious
I just purchased lift but I have not installed it yet
what gear ratio? how does your truck do towing with those 35s?
Do you need to recalibrate the speedo with 35/12.5-18? I heard the dealer can do it if needed.
Do you have a link to those rims ?
Vision Wheels
@@519Offroad hey man. My son just did this same exact lift on his 2019. He loves the look of your wheels. Do you know what the offset was??
@@macking4942 -25
will it require more or less cutting if it has a zero offset?
Put a plus offset and zero cutting.
@@jeffbennett8093 thanks, my 2020 Ram didn’t need any cutting with my 3.5” readylift with 35x12.50R20 Nitto ridgegrappler tires
How do you like the tires?
What’s the offset on those wheels? Sorry if you said it in the video
-25
Hey bro, what size are your Rims, 20x9? And the tires are 35x12.5
20 x 10
Definitely going back to quad cab from crew next truck.
Why so?
Did it change the ride quality at all? Stiffer? Thanks!
Front rides like garbage now
@@519Offroad damn! So I guess I’ll keep looking! Thanks!
Looks killer! I'm thinking of doing the same, how high is the roofline? Can you get into a parking garage?
Not sure how high I live in the county and never go into parking garages
Superhero cops lol!!
Looks good, that's a quad cab right?
Crew cab
That’s definitely a quad cab
Nice👍
Just wondering, did your gas mileage drop big time with the lift and tires ?
Yes and yes
dude get outta there come to Florida..
Just Sub'd.
Sweet lookin truck! Has a good stance to it. They definitely ride more stiff after a level lift but so worth the look! I prefer the leveled look over lifted any day!
I just uploaded a vid of my '14 Bighorn with home built level lift and 35's. Check it out on my channel