Samsung Galaxy Tab 3 USB Charging Port Repair
HTML-код
- Опубликовано: 10 сен 2024
- For daily repair posts follow on Facebook: / mobilelabuk
To find out more services and repairs we offer please contact us on Facebook =)
Mobile Lab
Gadgets Repair and Micro Soldering Specialists
Nottingham, United Kingdom
Steps Followed To Perform Repair:
1. Removed broken USB port by going over pads with low melt solder and using air gun at around 250 degrees.
2. Added flux and low melt solder to pads.
3. Used soldering wick to remove solder from pads.
4. Add more flux and make sure connector is aligned and flat with board.
5. Solder all pads with new solder.
6. Check connector and clean area with isopropyl alcohol.
extremely refreshing seeing someone taking the time to do this repair the correct way..cheers
perfect, I use 280 degrees in the work, good video!!!
It is a great video but you could comment a little, giving tips. Also, how do you get solder out of through holes wen you hold the iron on the hole and the solder doesn't seem to melt.
I use 440c on JBC Tese-Q it take 3 seconds to remove the old connector then i use jbc nanotweezers for cleaning the pads then apply solder to each pads and then i use 380 c to solder connector back
I replaced recently this 11 pins samsung usb port.To avoid the bridging nightmare as pcb cools it gets even worse i pre tin all the pins and then put it to solder back blowing it with the hot air mixed the solder from the pads with the pretined new.Then move a little the port in its place for the solder to apply evenly and thats all.Also avoiding to use desoldering wick as much as possible because there is danger to destroy pcb pads.Or sucking the solder with a desoldering gun or blow it to spread away with hot air in high pressure.
what type(s) of paste did you use for this repair???
hello, I tried but I never reach your skills, what is the right tempertures ? thanks
good job
Like a pro.i do the same :)
bro plz tell me about ur flux... really confused in flux types
I have a samsung tab 3 10.1 it's been off about a year because the charging port was bad,today i replace it and when i conected to the charger the battery logo come on, but like 10 seconds later the screen when off,i think it needs a new battery,somebody has any ideas? ???
which flux is it?
if my trik i use two solder to change usb...
YEA IT WORKS!!! THE DISLIKE BUTTON WORKS!!!
+rishad areefin What do you dislike?
Samsung Galaxy ace 3 no off USB Charging Port Repair SIMON SKARDON
Wat up u guys tried
Your namber
hello, I tried but I never reach your skills, what is the right tempertures ? thanks
hello, I tried but I never reach your skills, what is the right tempertures ?
+Rosher cruz It can vary depending on your hot air station. For mine after covering with low melt solder I use about 250 degrees
Hi, which speed do you setup on the hot air station? Lowest or highest speed? And which nozzle? The small,medium or large nozzle? Thank