Port work an tips on porting the 2511

[@richardguidotti8595]

The Zama carb off an ms200t fits straight on. You have to drill the hole out for the impulse and fill the original hole with epoxy. Other than that, change the butterfly spindles, to get the right linkage. A lot easier than I’ve made it sound.

[@simpleman4224]

Great info buddy! Thanks for sharing! 👍👍👍👍🇺🇸🇺🇸🇺🇸🇺🇸🙏🙏🙏🙏

[@NothingButChainsaws]

Your a freaking wizard at these little monsters....

[@jamesmihalcik1310]

Super awesome for describing your thoughts on the different types of builds depending on fuel economy and performance. Thanks for that! Have you opened one back up to see the pattern on the piston face after the builds?

[@slaxxx]

Awesome info. Thanks!

[@jacobhein4319]

Its crazy that fuel tank size is a porting limit on this saw. A carb swap would be sweet but if the saw doesn't hold enough fuel whats the point

[@Sethhaun78]

Then drilled a 3/8 hole rite just below that line all way threw exhaust baffle .and it's broke in of course but it out runs every tophandle including my new 201t.its only top handle I use daily except t540i battery saw.guna sell that junky 1000 dollar 201 t .could've bought 2 more echos..thanks

[@justinweaver8787]

I been behind on my videos im tryn catch up sir!!

[@Sethhaun78]

I'm no porter but ,on mine I just took limiters off ,put quarter pitch sprocket from saw again with sthil 14 inch polesaw bar AND chain

[@backyardfirewood9852]

Is that the one that you are taking to saw fest?

[@jackpinesavageadventures3142]

👍

[@raimonchannel]

nice broo

[@JKSawShop]

Let’s do a carb swap

[@markramirez4830]

Very thin at transfers😮