i finished my siboor voron v0.2 the other day. i still have to do tunes and stuff. i don’t have the adxl enabled, but it’s chugging along. the most difficult part was wifi access
I'm wondering if I'm even going to enable the wireless. I normally plug all my printers in with Ethernet cable. Leaves the wifi free for other devices. But it's very convenient to connect the printer via wifi. Congratulations for the build!
Thank you for this series! I'm building a Mini Stealthburner from my LDO v0.2 kit. The right-most position for the primary gear is still not enough to be centered with the filament path. The set screw doesn't allow to move the primary gear the last 0.2-0.3 mm closer to the T50 gear (original Bondtech BMG part), because the flat part of the shaft is too short. What would you suggest in this case?
That's odd. So it sounds like the primary gear is incorrect? If you grind the short side of the primary extruder gear, will it all fit into the print head correctly?
@@KapmansBasementWorkshop Thank you for your answer! It doesn't seem to be incorrect, but the D-cut is definitely too short, so I'll try to extend it first. There is at least one user on Reddit and one on the official Voron forum with the same issue with the new (white) Bondtech shaft assembly.
Thank you. Really enjoying the series. The V0.2 is on my list of future builds and the Siboor with supplied parts really interests me.
The supplied parts are nice! And the CNC parts eliminate most of the heat set inserts. Working on part 6 as I type. Thanks for the feedback!
Man, ur videos are so good! Thank you. If you have a 2.4 series, which I hope you do, that’s next up for me.
I do have a 2.4 series. It's one of my earliest videos of a blurolls kit I used. Hopefully you find that useful as well. Thank you!
i finished my siboor voron v0.2 the other day. i still have to do tunes and stuff. i don’t have the adxl enabled, but it’s chugging along. the most difficult part was wifi access
I'm wondering if I'm even going to enable the wireless. I normally plug all my printers in with Ethernet cable. Leaves the wifi free for other devices. But it's very convenient to connect the printer via wifi. Congratulations for the build!
@@KapmansBasementWorkshop i have cats, so hard lines are not a good fit. i need enable adxl and start my v2.4 350
Thank you for this series! I'm building a Mini Stealthburner from my LDO v0.2 kit. The right-most position for the primary gear is still not enough to be centered with the filament path. The set screw doesn't allow to move the primary gear the last 0.2-0.3 mm closer to the T50 gear (original Bondtech BMG part), because the flat part of the shaft is too short. What would you suggest in this case?
That's odd. So it sounds like the primary gear is incorrect? If you grind the short side of the primary extruder gear, will it all fit into the print head correctly?
@@KapmansBasementWorkshop Thank you for your answer! It doesn't seem to be incorrect, but the D-cut is definitely too short, so I'll try to extend it first. There is at least one user on Reddit and one on the official Voron forum with the same issue with the new (white) Bondtech shaft assembly.
Is that grease in the syringe or is it oil?
I used grease. Some use oil but I feel in the heat when enclosed, the grease works well.
"PromoSM"
PromoSM?