Love your video and ordered the voodoo exhaust for my Eliminator. But the lady in this video should get some half decent footwear for riding. Burns may be the least of her worries.
I really think you’re going to love the exhaust. It has a deeper sound I feel the microphone didn’t do justice to. She rides in Doc Martens now, no more little riding loafers 🤣
Awesome video, very creative and very entertaining too! Can you please point me in the direction to find the caps, even if it’s several different kits, any help is appreciated. Thanks
Got them, thanks a bunch. There are two smaller holes on each side at the bottom, I think I’ll get the 25 mm or 26 mm to see if they fit. Thanks again.
I only had to cut off an inch and three quarters (1.75”) to make sure the muffler was sitting correctly on the elbow the way it was in the video. That part is listed on Amazon, but I got it from Summit Racing, since they’ve got their store just a town over from me.
@@gamingbluemoon well Voodoo also makes the same reverse cone muffler in chrome, which wouldn’t look out of place with the stainless exhaust. So far though, haven’t noticed any issues.
So much BETTER, Well done 👍👍
great video! will definitley upgrade my Eliminator exhaust when other priorities permit. Will go for the "easy option", though!
Nice job ..sounds a lot better to me then it did man does..cool 😊
I got the same exhaust and it sounds so good
Love your video and ordered the voodoo exhaust for my Eliminator. But the lady in this video should get some half decent footwear for riding. Burns may be the least of her worries.
I really think you’re going to love the exhaust. It has a deeper sound I feel the microphone didn’t do justice to.
She rides in Doc Martens now, no more little riding loafers 🤣
Do you have a link for the caps you used for the frame holes
I was not ready for that much sexy ankle without a trigger warning at the beginning of the video. I'm going to have to subscribe now.
Funny video, and sounds much better than stock!
Haha!!! Loved it!!
You’ll lose the pop but a pair valve delete should clean up the sound more. Love the caps idea!!!
Awesome video, very creative and very entertaining too! Can you please point me in the direction to find the caps, even if it’s several different kits, any help is appreciated. Thanks
@@metamorfosis181 a.co/d/2A3ZGPv These are the caps I used, I got one set of 27mm, and in the also one set of 33.6mm.
Glad you liked the video!
Got them, thanks a bunch. There are two smaller holes on each side at the bottom, I think I’ll get the 25 mm or 26 mm to see if they fit. Thanks again.
Hey do you have a measurement for the pipe you cut, or where you got it?
Found it, it's a walker 41734 like it says on the paper lmao
@@LittleTas12how much you cutoff?
I only had to cut off an inch and three quarters (1.75”) to make sure the muffler was sitting correctly on the elbow the way it was in the video. That part is listed on Amazon, but I got it from Summit Racing, since they’ve got their store just a town over from me.
@@tiffinhappy9744 Inch and a half on the small side to fit into the exhaust.
I have no intention of messing with the cat by painting it. Can mess with heat distribution.
@@gamingbluemoon well Voodoo also makes the same reverse cone muffler in chrome, which wouldn’t look out of place with the stainless exhaust. So far though, haven’t noticed any issues.
@@jackisoutside watch the wrap. They tend to rust out exhaust systems.
Which bar risers did you get?
Just some Amazon specials a.co/d/5SJ7SxV
The point out that your right foot should be on the peg as you leave from a stop anyway
Amazing Acting! Lol