Like someone mentioned, the end lines in the videos have the cone spacers in difference places compared to the instruction. It varies depending on your setup.
this is completely wrong from the instructions you sent. it shows the larger cone spacing going on the female end. it also shows the large cone spacer on the nut side, not the bolt side. Can you explain which one is correct?
@Spencer we apologize for any confusion. You are free to manipulate the cone spacers in any combination that would achieve the 90 degree endlink angle to the LCA.
@@asr3596 same, was wondering why the endlinks were at an angle after following the printed IFUs to the T. Wasn't aware that the cones can be at any combination.
@4:02 - The lock nut at the end of the bolt. Any chance of the nut coming lose as it looks to be sitting right at the edge. What is the best way to prevent this, Red Locktite?
mine has fallen off 3 TIMES! Only on the right side of my car too as It keeps banging against my axleback. The nut is a locking nut but it seems like its not holding well
Like someone mentioned, the end lines in the videos have the cone spacers in difference places compared to the instruction. It varies depending on your setup.
this is completely wrong from the instructions you sent. it shows the larger cone spacing going on the female end. it also shows the large cone spacer on the nut side, not the bolt side. Can you explain which one is correct?
@Spencer we apologize for any confusion. You are free to manipulate the cone spacers in any combination that would achieve the 90 degree endlink angle to the LCA.
@@asr3596 same, was wondering why the endlinks were at an angle after following the printed IFUs to the T. Wasn't aware that the cones can be at any combination.
@4:02 - The lock nut at the end of the bolt. Any chance of the nut coming lose as it looks to be sitting right at the edge. What is the best way to prevent this, Red Locktite?
mine has fallen off 3 TIMES! Only on the right side of my car too as It keeps banging against my axleback. The nut is a locking nut but it seems like its not holding well
Looks like you guys installed all the ek stuff on a eg
no preload?