AtGames Pinball DMD Mount for VSDISPLAY 8" LCD

How to mount a VSDISPLAY 8" LCD in an AtGames Pinball Cabinet using laser cut custom mount
Required Parts:
VSDISPLAY 8" Bare LCD // www.amazon.com...
Extender Cable // www.amazon.com...
VSDISPLAY 8" Mounting Kit for AtGames Pinball Cabinet // creativeartsan...
Optional Add On
ALP Apron LED DMD // creativeartsan...

[@AskUncleDavecom]

So basically you didn’t need to remove anything . Just drill a hole through plexiglass and wood with a drill
Why didn’t you film it working
Did you break it?

[@opengadgets]

I have seen a few guys go that route with success. No , it did not break in my case , here it is action ruclips.net/video/KLb93JNejiQ/видео.htmlsi=6Kvt6vM44HD-tw49

[@gunstarherouk]

Thank you for this gives me idea to remove front glass as I want to cut out the atgames logo and put a lcd panel in there, have to go and buy a hotgun

[@nicholasmoreno9584]

i was thinking about doing this also, i wish there was a bezel kit like this for the marquee display so i could just tape it over top the glass the same way

[@CarlG-n3v]

Hi,
Thank you for your great video.
I bought everything you advised, and then got to the ending.
but you didn't show what gets plugged into the HDMI input on the DMD controller board
and
the HDMI input on the VIBS board
and the HDMI input on the upper left hand top corner of the playfield.
There are 3 HDMI inputs, but my laptop only has ONE HDMI output ..
can you please explain the final connection steps ?
Thank you !!!
:)

[@opengadgets]

you'll need 2 HDMI outputs, one goes to the HDMI input on the upper left hand top corner and the other to the VIBS board

[@DaBadSeed]

Nice video I think I may try this

[@avatar6699]

Will this screen setup fit on the Legends MicroVPinball?

[@opengadgets]

My guess is not but I don’t have a micro either