Teflon tape should be applied WITH* the threading, not opposite of it. This is so that when you thread on the female end, it doesn't unravel the teflon tape you just applied but rather goes with it. Other than that correction, great video.
For starters you using the swing assembly the wrong way round. The Marlex 90 screws into the bottom of the head for maximum flexibility at the head, not into the pvc fitting, which also is usually at that point not an FA. But could be if you used a swing MA.
why not just use poly instead of thin, extremely eazy to crack class 200 pvc? So much unessacery work gluing all the fittings they will eventually leak through the joints, especially since you didn't wipe your joints clean.
Teflon tape should be applied WITH* the threading, not opposite of it. This is so that when you thread on the female end, it doesn't unravel the teflon tape you just applied but rather goes with it. Other than that correction, great video.
For starters you using the swing assembly the wrong way round. The Marlex 90 screws into the bottom of the head for maximum flexibility at the head, not into the pvc fitting, which also is usually at that point not an FA. But could be if you used a swing MA.
For such a small area I am surprised that you used a rotary.
You've done good work. I may refer to this later on. Thank you.
Would suggest the end compression be an elbow facing up. If anything breaks or requires maintenance down the road it will be easier to do.
🤩🤩🤩
why not just use poly instead of thin, extremely eazy to crack class 200 pvc? So much unessacery work gluing all the fittings they will eventually leak through the joints, especially since you didn't wipe your joints clean.
Pipe tape applied wrong. Need more research. ;)