Rolling it with a pin quickly after will help with pressure. Cylinders have very narrow point of contact allowing for quite high PSI with low force required
Probably the most useful video on the matter. Can I ask you which brand of tape seam are you using in this video? I'm trying to find me some, but all I get are brandless single stripe, not a big roll like your
You can just turn the sleeves inside out, remove old seam tape, then reapply where needed. Armpits and hood might be tricky because of their curvature but it’s doable
![MISSING: SLIM SHADY [Expanded Mourner’s Edition Trailer]](http://i.ytimg.com/vi/xh8qgHrOO1g/mqdefault.jpg)
Rolling it with a pin quickly after will help with pressure. Cylinders have very narrow point of contact allowing for quite high PSI with low force required
Wow a useful video, thanks and great job.
Thank you
Thanks for a very useful and informative video.
Good vid J i bro. I was thinking of doing a repair. On one my jackets. Thank you. Cheers 🍻
Thank you. I hope it goes smoothly
Dont leave the iron down or your going to do something fucking bad... Roger that.
I've also used flex seal with great success on packs, pack lids and gortex jackets.
I CUT THIS BOAT IN HALF
I used flex seal on an Alice pack lid but it just ended up flaking off all time. Did you use the spray or the liquid can?
@@KitCreepwhich one did you use, spray or brush on?
@@Gonzo.S.Thompson spray on. I tried dipping a pump for my shotgun in a can of flex seal and had the same flaking issue.
Probably the most useful video on the matter. Can I ask you which brand of tape seam are you using in this video? I'm trying to find me some, but all I get are brandless single stripe, not a big roll like your
Im not sure what brand it is. I got it off Amazon
Good job 👍
Dude what jacket are you wearing it looks nice
PCU level 6. The video I posted before this one talks about it
How hot is the iron set for?
W information
Good info
What do you do when all you have is the sleeves and hood that are the only parts wth the coating
You can just turn the sleeves inside out, remove old seam tape, then reapply where needed. Armpits and hood might be tricky because of their curvature but it’s doable
Dude. Nice.
stay dry or get wet?