DIY: Screwdriver Rack/Holder

When I bought a full set of new screwdrivers, I didn't have a good place to put them, so I built a good place to put them. I used only scrap wood I already had on hand.
This is NOT a sponsored link, but the set of screwdrivers I bought is from Harbor Freight, as seen here: www.harborfrei...
NOTE: footage and photos were recorded throughout early July 2024. Voiceover and editing were done on July 21, 2024.
#tools #diy #garage #shop

[@AndersonConnors]

Good job! (Not just the project, but the video!) Lots of useful footage in this one.

[@Chan_Fry]

Thanks! I think I did a better job on this one (than my last few) of planning ahead of time, as far as what kind of video I'd like playing while I talked. :-)

[@waynebenedict5785]

Never thought I'd say this to a guy, but, nice rack! Good use of scrap wood, well done!

[@Chan_Fry]

@@waynebenedict5785 Thanks!

[@waynebenedict5785]

I have mine either in my roll around tool box or on my peg board with the metal hoop sets.

[@Chan_Fry]

@@waynebenedict5785 I did consider the peg board option, but wall space is at a premium (at least on the workshop half of the garage). :-)

[@kennethkline7702]

You should have just drilled holes in the shelf and put the screwdrivers into those holes.

[@Chan_Fry]

That's definitely an idea that I didn't think of. :-) I think I probably wouldn't like that, given that a couple of these have 8-inch shafts, which would interfere with the shelf below. Plus, this way, I can always re-locate the rack if I want/need to. Thanks for watching!