Pag nag calculate ako ng 32560 capacity kasi wala ako capacity tester, 5500 yung ginagamit ko na value. May mga test na rin kasi na yang 6000 mah "daw" d tlga yan naabot lalo na mga 2nd hand 32650 batteries na yung mga nabibili natin.
hi I connected this bms with 4 6500mhA (approximately) life4po 3.2V batteries but I can't recharge the batteries, I managed to do it using 14.1volts (using a 3A voltage regulator) but it took me 4 hours! !! I tried with a more powerful power supply but it burned out! Too bad it was new! I'm going crazy because I needed to charge them with 12 volts... what a disappointment, so much wasted money I made before and it cost me less if I bought a motorcycle battery!!!
Did you checked the output voltage of the bms before you chagre? Sometimes the bms you bought is need to short or charge to activate the components. Heres another tips after you bought that bms you need to check the color coding of the wire sometimes the color coding is opposite to the label of bms
@@jovsd.i.yprojects I don't like those thin wires, since they are 6.5A I chose to solder the wires b0-b1-b2-b3-b+ directly on the electronic board to have a greater capacity. the bms was charged as I said before and it reached 14.46 volts so full charge only that I had to use a voltage regulator to get 14 volts... is it normal that it has to recharge at 14 volts???? among other things, it loads slowly...very!
@@powerROBY yes its normal 32650 battery is 3.6v if fully charged and series in a 4 so you get a overall voltage of 14.4v.The stable or rest voltage is 13.8v something.so you need to set the regulator to 14.6v or 14.4v to charge the battery
Boss same tayo ng bms. Bakit po kaya yung sakin hindi nagBalance yung mga battery nung ginamit ko na at nagdischarge na. Pero pare-parehas naman sila ng capacity at full charge lahat bago ko iassemble. Ano po kaya ang pwede ko gawin?
@@jovsd.i.yprojects sa akin sir same sila lahat 3.29volt isana lang Hindi same NASA 3.24 volt. Pwde build na po lahat Kasi 16pcs 6000mAh magiging 24ah lahat.. mayron bms with active balancer na maliit na ampers sir pwde ako hingi link f mayron kayo. Tnx
@@jovsd.i.yprojects sir sa akin 32650 6000mAh volt Niya NASA 3.29 Isa lng Hindi same nasa 3.24 volt lng. Pwde po ba build nalang wlang top balance.? Mayron ba 4s bms with active balancer na maliit ampers. F mayron pwde hingi ako link. Sana masagot mo tanong ko. Tnx
Ayos idol thanks sa share
Thank u lods
Pag nag calculate ako ng 32560 capacity kasi wala ako capacity tester, 5500 yung ginagamit ko na value. May mga test na rin kasi na yang 6000 mah "daw" d tlga yan naabot lalo na mga 2nd hand 32650 batteries na yung mga nabibili natin.
Oo gnun talaga para makasigurado kailangan direct supplier talaga bos sa china
Watching idol ☺️
Thank u lods
hi I connected this bms with 4 6500mhA (approximately) life4po 3.2V batteries but I can't recharge the batteries, I managed to do it using 14.1volts (using a 3A voltage regulator) but it took me 4 hours! !! I tried with a more powerful power supply but it burned out! Too bad it was new! I'm going crazy because I needed to charge them with 12 volts... what a disappointment, so much wasted money I made before and it cost me less if I bought a motorcycle battery!!!
Did you checked the output voltage of the bms before you chagre? Sometimes the bms you bought is need to short or charge to activate the components. Heres another tips after you bought that bms you need to check the color coding of the wire sometimes the color coding is opposite to the label of bms
@@jovsd.i.yprojects I don't like those thin wires, since they are 6.5A I chose to solder the wires b0-b1-b2-b3-b+ directly on the electronic board to have a greater capacity. the bms was charged as I said before and it reached 14.46 volts so full charge only that I had to use a voltage regulator to get 14 volts... is it normal that it has to recharge at 14 volts???? among other things, it loads slowly...very!
@@powerROBY yes its normal 32650 battery is 3.6v if fully charged and series in a 4 so you get a overall voltage of 14.4v.The stable or rest voltage is 13.8v something.so you need to set the regulator to 14.6v or 14.4v to charge the battery
Lods sa akin 2 weeks pa lang biglang nag loko Yung bms 10v Lang Yung output niya Tama naman Yung wiring
Charge mo sir kapag ayaw talaga tumaas palit ka bms
Sir ganyan ba din pag sa solar na charging jan sa may female plug na ba sa output na cya recta?
Kapag meron ng scc ung input ng scc lgyan muna agad ng abang
idol anung size nyang AWG wire mo?at mag kanun nman isang roll?
Automotive wire main #12 at 14 naman sa mga dc load at switches
Sir ano po charging voltage and charging current required ng 4S5P?
14.4v stable sa 13.8 or 14v
Sa akin yung charger gmit q 5amps
Boss pwede kaya ang bms na 10apre lang gamitin sa 4s 5p or kelangan nag mas mataas na amp na bms?
Ok lang po yan sir basta mababa lang namn yung load.
Oo boss. Mababa lang. Dally yung bms ko 16a pala nakalagay .. load ko dpa naanoy sa 5a salamat bos
paano ba eh match ang bms sir sa gusto mo eh assimble na battery
Kung ilang series yung gagawin mo na battery ganun din ang bms na bibilhin mo sir
Panu po ung balancer
Same lng po connection sa bms sir
Ask ko lang po, 18650 po na bms board is different po ba sa lifepo4 na bms or oks lang gamitin yung bms for both batteries?
Magkaiba po kapag mgbubuo ka ng 12v set up ang 18650 bms ay 12.6v sa lifep04 namn ai 14.4v kaya nd po pwede
Got it, salamat poo
Sir paanu po kpg ung bms output ndi umabot ng 12v?ang reading lng ay 8volts or 9v.ibig savhn sira na po?
Nd po sir charge mo muna ang bms para maactivate
Sir ito po kung bkit mababa ang voltage ng bms ruclips.net/video/UDvUx_f9WQ4/видео.htmlsi=c4xJWhGX5IDn7RjV
Boss same tayo ng bms. Bakit po kaya yung sakin hindi nagBalance yung mga battery nung ginamit ko na at nagdischarge na. Pero pare-parehas naman sila ng capacity at full charge lahat bago ko iassemble. Ano po kaya ang pwede ko gawin?
Subukan mo lagyan ng active balancer sir
@@jovsd.i.yprojects boss di ba may balancer na kasama ang bms na katulad ng gamit mo?
para san po ung bms bos?
Yan po nag cocontrol sa charge at discharge ng battery
boss saan po nabibili mga parts?
Shoppe lng boss wala pa kasi aq stock
Idol 4s 5p ba tlaga Yan? Or 4s2p
ruclips.net/video/N8YX_57Luzs/видео.html
Paano i charge yan boss?
Gamit lang ang lifepo4 ac charger 5amps pwede rn sa solar sir
Sir hinda ba kailangan e top balance si 32650?
Pwede sir. para pag install mo balance n sila
@@jovsd.i.yprojects sa akin sir same sila lahat 3.29volt isana lang Hindi same NASA 3.24 volt. Pwde build na po lahat Kasi 16pcs 6000mAh magiging 24ah lahat.. mayron bms with active balancer na maliit na ampers sir pwde ako hingi link f mayron kayo. Tnx
@@jovsd.i.yprojects sir sa akin 32650 6000mAh volt Niya NASA 3.29 Isa lng Hindi same nasa 3.24 volt lng. Pwde po ba build nalang wlang top balance.? Mayron ba 4s bms with active balancer na maliit ampers. F mayron pwde hingi ako link. Sana masagot mo tanong ko. Tnx
@@ramiesarsalejo9547 meron kang mbili n meron active balancer daly bms meron syang kasama sir