Imam bmw e87, motor m47, velika potrosnja ulja 2 litra na 1000km. Sta uraditi, sta zameniti. Turbo sam remontovao, nemam ulja u interculeru da sumnjam na turbinu, sta dalje da zamenim? Molim za pomoc.
Hello friends, I was tired of my BMW 39. It stopped suddenly. I replaced the main high-pressure pump, replaced the external and rear pump actuation, replaced the fuel sensor and the governor sensor, and the engine still does not start. It runs well, the battery is strong, the diesel comes out of the governor strongly, the injectors are clean, the diesel filter is new, and the oil filter is new, but The car does not start, the sprayer just turns on and off. Note that my car has a fully electric motor and there is a code attached to the key that is programmed to start. I am afraid that the code has been lost. Please help. Thank you. I am in Syria.
Also check the relays under the dashboard and you must bear in mind that if it is tried many times to start, they must be aligned and the EWS with DME will not start otherwise.
If you measure the input voltage of the fuel pump and it is "0", it means that the defect is somewhere else, the safety is good. Only the relay remains as defective. You can do an easy check by replacing the relays between them, if it starts for sure it is defective.
Thanks for your help. Very good clip.
Same problem e39 528i, but I didn't find the green relay in the bottom drawer of the dashboard
if your e39 is older than 2001 it may be in the back next to your battery
Mine is 523i, 1996, e39, I also can't find the relay under the glove box
But I saw 3 behind the boot, is that the fuel pump relays?
Imam bmw e87, motor m47, velika potrosnja ulja 2 litra na 1000km. Sta uraditi, sta zameniti. Turbo sam remontovao, nemam ulja u interculeru da sumnjam na turbinu, sta dalje da zamenim? Molim za pomoc.
Hello friends, I was tired of my BMW 39. It stopped suddenly. I replaced the main high-pressure pump, replaced the external and rear pump actuation, replaced the fuel sensor and the governor sensor, and the engine still does not start. It runs well, the battery is strong, the diesel comes out of the governor strongly, the injectors are clean, the diesel filter is new, and the oil filter is new, but The car does not start, the sprayer just turns on and off. Note that my car has a fully electric motor and there is a code attached to the key that is programmed to start. I am afraid that the code has been lost. Please help. Thank you. I am in Syria.
call someone to read codes
Also check the relays under the dashboard and you must bear in mind that if it is tried many times to start, they must be aligned and the EWS with DME will not start otherwise.
Hello, do you mean the computer card? @@JHAMS.001-car-repair
How do you know the relay it's faulty?
If you measure the input voltage of the fuel pump and it is "0", it means that the defect is somewhere else, the safety is good. Only the relay remains as defective. You can do an easy check by replacing the relays between them, if it starts for sure it is defective.
@@JHAMS.001-car-repair thx
@@JHAMS.001-car-repairvolatage*
@@JHAMS.001-car-repair what/where is the safety? im not getting any voltage to the Fuel pump unless I jump the relay
@@talibanshooter_696
if you have voltage when you bypass the relay, it means that it is defective.