For those who don't have that oil filter remover thing, I just hammered a screwdriver about the end of the oil filter until it's out from the other side, pushed it anti-clockwise that's how I got it out. Because I had the new replacement anyways, I thought it'd be easy enough to get it out with bare hands.
Me too ... but people who are gonna do that should make sure that they know where the engine thread ( pops out ) is ... if they try to insert the screwdriver at the starting point then they'd damage the popped out engine thread bolt oil passage .....
@@AutoFix-Telugu tq for info bro ... I'll cold start and let it run for exactly 3 minutes , no revving... then I'd drain oil ... put on new pre oiled oil filter, then new oil .... this is good or anything should I take care of extra
Used Motul 7100, will post the review after few days…
Oil ekkuva fill chesthe Chala problems vasthay oil seals leak avthay oil burn avthadi performance reduce avthadi. 50 to 100ml ithe no problem
IDEAL SOUND WAS CRAZY DUDEE
For those who don't have that oil filter remover thing, I just hammered a screwdriver about the end of the oil filter until it's out from the other side, pushed it anti-clockwise that's how I got it out. Because I had the new replacement anyways, I thought it'd be easy enough to get it out with bare hands.
Me too ... but people who are gonna do that should make sure that they know where the engine thread ( pops out ) is ... if they try to insert the screwdriver at the starting point then they'd damage the popped out engine thread bolt oil passage .....
Y using motul .... Service centre oil bagundada??? Any difference
OEM oil bane undi but motul Konchem better anpinchindi gear shifting batter smooth undi
bro is engine powder coating is reliable, and what would be the costing please tell me?
It will be good, and I believe it costs around 6k.
Bro hand tightening is enough for oil filter ??? Sure ?? No need of oil filter wrench ??
Yes, since 5 years I am following the same for my GT. if you have doubt just check for any leaks once u start the engine…
And should I start my bike and leave it for 5 minutes before draining oil ?? Or can directly drain oil from cold engine ?
We can drain from cold engine but flow rate will be slow and there other reasons too so breed to warm up engine
Avoid changing the oil when the engine is extremely hot, as the drain bolt may break
@@AutoFix-Telugu tq for info bro ... I'll cold start and let it run for exactly 3 minutes , no revving... then I'd drain oil ... put on new pre oiled oil filter, then new oil .... this is good or anything should I take care of extra
Oil akkythe m ayina problem bro?
ASMR ✨
Bro oil come in 1 litre nd 1.5 litre so how to mange 3.1 litre if you r buy 1.5 (2bottel)then 3 litre only so what i do for 100ml pls reply bro
That is the problem here we need to buy 1l for that 100ml…
1.5 L + 2*1 L . You will have 400ml left which you can use for topup.
Oil filter remover tool link bro
amzn.to/3p1BODb
What is the tyre size 7:27
150/70 -R18
Bro na bike front fork wobbling issue undi problem ardam kavadam ledu
Check:
Tyre pressure (recommended 32psi front)
Wheel alignment
Cone set bearing
Any oil leaks from suspension
Bhai Oil filter kha se liya... Service centre walo ne alag se nhi diya
I got it from automobile shop
You can order from throttleandthump (Instagram page)
rear tyre setup ??
pirelli scorpion trail 2 150/70 r18
Bro engile oil
Cost yantha bro
Around 3000