3d printed 2d printer prints a print of itself
HTML-код
- Опубликовано: 5 окт 2024
- It is controlled by means of an arduino with a grbl shield, wich drives the x and y motors, and the solenoid used for lifting-lowering the pen in response to g-code generated in inkscape and sent through grbl controller.
It was designed with FreeCAD, and so is the blueprint made.
This was recorded in 2017.
Files and more information here:
www.thingivers....
juangg-project....
Help keep this going: www.paypal.me/... - Наука
Incredible work! What if instead of just sliding around on the desk, you put a few rollers and round ramps on both ends so the paper shimmies up into the air as it moves. If not practical, at least it will look funny.
I found it is best to put it on top of something so paper falls down on both sides. What you say would keep the paper clear from the pen when it is raised, it could improve results especially with markers and such.
Your project is very top, would you be able to provide the files to print the parts?
Здравствуйте , прекрасный проект . Если не жалко поделитесь STL моделями ,чертежами Вашего проекта
What software do u use for inserting drwings?
Hello! Nice job! How do you get such flat drawings from a 3D model? Some plugin?
Thanks! Drawings are made directly within FreeCAD. No plugin required IRC.