12:00 I hear filing back and forth. File toward the inside only and then deburr before placing in the cylinder. There will be burrs to be removed from that large file being used.
Are all the pistons the same? I thought you would gap each one for the hole it came out of.i guess it won’t matter much cuz the cylinder walls look a little rough
7:30 Check those ring gaps again. You said .009" was good and I'm thinking .020" is more like what you want. Use your piston with a ring on it to get uniform depth.
Watched it all. That one piston looked rough around the edges.
Keep plugging at it.
Thanks, I’ll go over it again. You have lots of good advice ha, I need all the help I can get! 😊 I appreciate your time
Loooove it
12:00 I hear filing back and forth. File toward the inside only and then deburr before placing in the cylinder. There will be burrs to be removed from that large file being used.
Ooh that’s good advice, thank you
Are all the pistons the same? I thought you would gap each one for the hole it came out of.i guess it won’t matter much cuz the cylinder walls look a little rough
I have all the pistons numbered for the one I took it out of
7:30 Check those ring gaps again. You said .009" was good and I'm thinking .020" is more like what you want. Use your piston with a ring on it to get uniform depth.
Yes thank you! I remeasured them all to about .020”
15:30 I hope you don't need that piston.