Corrugated Fasteners

I bought this spotnail RC1016 corrugated fastener and it uses Senco 1" crown corrugated fasteners.
If you are interested in buying any of my wooden crafts, check out my Etsy store: www.etsy.com/shop/EngWoodworking
Visit my website at www.engineeredwoodworking.com
Email me at [e-mail]
Try Amazon Prime Free for 30 days: goo.gl/z1SWKR
Tools and Items used in the video:
Corrugated Nailer (Spotnail) : amzn.to/2w2sBxI
Corrugated Nailer (Senco) : amzn.to/2vZcJfm
Corrugated Fasteners: amzn.to/2vZ5OTa

[@robertlacasse6679]

That will be the next addition to my workshop. I also liked your table and chair video also.

[@EngineeredWoodworkingandDIY]

Thank you for the kind words Robert. Have you also seen my Bus Conversion series that I recently started?

[@ArtsCraftsJoe]

Cool video, thanks for sharing.Been hammering mine in. It a little messy.

[@theoriginalmonstermaker]

Damn! First time I've seen this tool... just heard it referenced in another vid and didn't know what they meant but that is GREAT for certain applications... maybe even joining baseboards over long runs of wall?
(Though id still cut them at low angle to reduce seam visibility)... but then you can hit it from back w this and have em sit nice and tight... cool stuff. 😎

[@rsanchez7111]

Thanks for sharing. How much did the gun cost and se no staples as well thanks before hand

[@joebarfield1]

do you use the same nails when the boards are at 90 degrees?

[@severalwhitespaces]

When you shear the fibers of the wood with something that size, is the loss of transverse strength noticeable?

[@SuperLittleTyke]

Would this method work to join two thin sheets of MDF edge to edge? The sheets are 1200mm x 600mm x 6mm. They are laid down on the carpet in front of a workstation to make rolling an office chair easier. Otherwise the chair castors get trapped in the carpet. Note that the MDF is really thin!

[@FinishedProject]

Have you used this to attach face frames to a cabinet carcass from the inside? And how did it work?

[@nazmiaksu6835]

Hi, what brand compressor would you recommend for industrial use? Thanks 🙏

[@eddyflynn213]

how much did it cost

[@howardtoob]

Do you need to use glue if using these fasteners?

[@adamlastero5424]

can you show how it shoots across the room?

[@EngineeredWoodworkingandDIY]

Probably not. LOL

[@Volcker1929]

That is literally the first thing I did the first time I used a nail gun. Ill advised, but fun.

[@jessicareyes-classen402]

😂😂

[@rsanchez7111]

😂😂😂😂

[@danielrabelo6732]

How do you remove them? That’s what I’m trying to do :/

[@HMBDoc]

you don't without destroying the project... cabinet installer/builder by trade.. and its dang near impossible to get them out clean

[@Ben-be1nn]

Love how he says it's so dangerous but yet the goggles lay there on the bench. Lmao

[@handymanbrian8269]

did you ever try it on melamine board?

[@EngineeredWoodworkingandDIY]

This is a melamine board.

[@handymanbrian8269]

@@EngineeredWoodworkingandDIY ahh. thanks. wasnt looking at the board...just admiring the gun lol

[@bweakley1509]

Corey smith