Valve Adjustment Husqvarna, KTM, Gas Gas 250 and 350! (2019 to 2024)
HTML-код
- Опубликовано: 18 сен 2024
- Fairly easy step by step valve check and adjustment anyone can do with a few simple tools! Save yourself a ton of money by doing it yourself!
Tools:
buy in advance a set of valve shims!
Sockets etc
metric feeler guage
Digital caliper micrometer
magnet
boldness, determination and a bit of patience!
Tips:
Disconnect the wire loom holder above the valve cover so you can pull the loom over to the side to get it out of the way of the vent tube,
Don't forget if you adjust the valves and put the lower bolt in to hold the crank to remove it again and replace the washer before trying to start it!! :)
Check the spark plug or replace while you are in there! The 250 and 350 plugs are a bear to get in and out!!
Simple yet effective video. Thank you sir, you make this job seem much less intimidating!
you are welcome! yea, just take your time and you can do it! Blessings from here in Tbilisi!
thanks so much!
Hello! I also live in Georgia and own a Gasgas with a similar engine. I was wondering, where did you get valve shims for this job?
Hi! I ordered them on Amazon through USA2Georgia. Takes a few weeks but you can get a kit with lots of sizes, Probably you can get them at the Husky center here in Tbilisi as well.