Hi, gap is set by adjustment of bearing assembly. Expeller is flush against shaft shoulder. If you have any technical questions, please feel free to contact our service department via email at customersolutions@welco.ca. Thanks!
@@WelcoExpediting if in a slurry pump , pump suction line & delivery line blocks what may be the possible reasons?whether any thing be checked from pump side
Very good.
Thank you!
What is the average MTBR or MTBF?
Depends on use/application. Please contact us via welco.ca for technical information. Thank you!
What about gap between expeller and backliner ?
Hi, gap is set by adjustment of bearing assembly. Expeller is flush against shaft shoulder. If you have any technical questions, please feel free to contact our service department via email at customersolutions@welco.ca. Thanks!
You have mentioned one impeller adjustment what is that adjust used for
We adjust the impeller to center within casing and prevent binding.
@@WelcoExpediting if in a slurry pump , pump suction line & delivery line blocks what may be the possible reasons?whether any thing be checked from pump side
@@manikandanmadhuvappan8166 Probably best to contact our service department with any technical questions, www.welco.ca/contact-us Thanks!
♥️♥️♥️♥️
I love pumps assembly
No volute seal on that pump
Hi, no volute - millMAX Pump.
Hell yeah Krebs is what's up.