Nice MUSTANG ... I am looking to buy one 2005-2009 too TAKE OFF the intake or buy a better socket or ratcheting 27mm closed end or use channel locks The way you are turning the tensioner and bolts for the throttle body - are they reverse thread ???? You are turning left to tighten ?? Am surprised these first run Mustangs are so cheap used, I'd prefer a stick
Iam taking them off the right way. It just looks wrong because of how the video is recorded. It my wifes car she absolutely loves it. Yes, a 5 speed would be much better. Im lazy so removing the intake was out.of the question Would it made it easier? Depends on how much work you feel like doing.
Any torque specs for these bolts? Can't really find anything about it. Anyways, This would be like the only time I would use my 27mm socket and wrench, it's oddly specific.
Nice MUSTANG ... I am looking to buy one 2005-2009 too
TAKE OFF the intake or buy a better socket or ratcheting 27mm closed end or use channel locks
The way you are turning the tensioner and bolts for the throttle body - are they reverse thread ???? You are turning left to tighten ??
Am surprised these first run Mustangs are so cheap used, I'd prefer a stick
Iam taking them off the right way. It just looks wrong because of how the video is recorded. It my wifes car she absolutely loves it. Yes, a 5 speed would be much better. Im lazy so removing the intake was out.of the question
Would it made it easier? Depends on how much work you feel like doing.
@@MyGarage-uu5ld YEAH figured that out later, your camera is recording a reverse image, should be easy to figure it out and fix it
Hopefully by the next video.
Thank you the feed back I greatly appreciate it..
FYI this video is mirrored so the left side looks like the right and visa versa.
As I said in the video it was that way. Nothing I can do about it. Unless I spend a lot of money I don't have for a GoPro. Thanks for watching.
No hate, Thanks for making the video. I much prefer this to manuals. @@MyGarage-uu5ld
@@JamesRhodes1941 you are most welcome, I'm glad you found it helpful....
Any torque specs for these bolts? Can't really find anything about it.
Anyways, This would be like the only time I would use my 27mm socket and wrench, it's oddly specific.
I'm not sure. I couldn't find anything. I just made sure they were both tight.
44nm or 32ft/lb. Found it from workshop manual.
@@bluesideup7891 awesome thank you for that information. I appreciate it..
Did it fix the noise?
Yes it did...