DIY custom throttle cables using soldered and screw type nipples on my BMW R100 cafe project

In this video I make custom length throttle cables using both soldered nipples and screw nipples on my BMW R100 cafe racer project. you'll see how easy it is to make your own custom control cables for your build making it a lot quicker, cheaper and all in house

[@Eight20]

Good work buddy, love that throttle snap!

[@twistedfatebuilds]

Thanks Ben, so do I buddy I was a bit worried but no need it's perfect at both locks 💪

[@jawracing911]

Brilliant job again mate. Now I know where to get my cables done at….😋

[@twistedfatebuilds]

Cheers mate, it's such a cheap and easy thing to have a crack at 👌

[@JamesDeVile]

How's the solderless nipple holding up? I'm in the same boat, I'd need to dip and solder with the cable on the bike. Screw type just seems more sensible...

[@twistedfatebuilds]

Still holding up fine James. Haven't had any issues buddy

[@bellinmi]

Who makes your clutch and hand brake levers?

[@twistedfatebuilds]

These are a "generic" make of a popular one! If you search RCS 19 on ebay you'll find them buddy 😉

[@nicholasjheinz7461]

Your camera is all over the place making video very hard to watch! Get a camera stand!

[@twistedfatebuilds]

Maybe get another video to watch

[@nicholasjheinz7461]

@@twistedfatebuilds After 5 minutes I did just that.