im using Nordson adhesive system too. I have a lot of troubles with this kind of needles and blocks my nozzle. I did cleaning the system more than six times and still i see that kind of needles. I dont know from where they came. any suggestion please? thanks
The cleaning action of the SureBead product is by virtue of the tip of the needle passing beyond the seat area and into the exit orifice to punch through any blockage. Needles are rigid components and cannot move through a nozzle that is not straight through. Therefore, it is not technically possible for this technology to be applied to right angle nozzle or any other arrangement where the exit orifice is not in line with the axial movement of the needle.
What I meant was that if the nozzle is horizontal, the whole gun would be operating horizontally and the particles would stay on the bottom side of the shaft instead of dropping by gravity in a vertical arrangement as in the video.
There should be no issue with horizontal application. Particulate will tend to flow with the adhesive, in which case it would normally enter the nozzle and be handled as if the module were vertical. If it does fall out of suspension within the module without transitioning into the nozzle orifice, then it cannot block the nozzle.
I need its part number
Posible to use at problue 10?
im using Nordson adhesive system too. I have a lot of troubles with this kind of needles and blocks my nozzle. I did cleaning the system more than six times and still i see that kind of needles. I dont know from where they came. any suggestion please? thanks
Hello,we are manufacturer of hot melt glue machine,if you have needs ,please contact with us.
whatspp:+ 85 131 6457 6609
And how about horizontally operated nozzles ?
The cleaning action of the SureBead product is by virtue of the tip of the needle passing beyond the seat area and into the exit orifice to punch through any blockage. Needles are rigid components and cannot move through a nozzle that is not straight through. Therefore, it is not technically possible for this technology to be applied to right angle nozzle or any other arrangement where the exit orifice is not in line with the axial movement of the needle.
What I meant was that if the nozzle is horizontal, the whole gun would be operating horizontally and the particles would stay on the bottom side of the shaft instead of dropping by gravity in a vertical arrangement as in the video.
There should be no issue with horizontal application. Particulate will tend to flow with the adhesive, in which case it would normally enter the nozzle and be handled as if the module were vertical. If it does fall out of suspension within the module without transitioning into the nozzle orifice, then it cannot block the nozzle.
Thanking you much, have a good day.
We are manufacturer of Hot Melt Glue Machine,if you have needs ,please fell free to contact with us :)
whatsapp:+86 131 64576609
Thank you.
Merhaba bizimki yukarı doğru atıyıor ve çok sızdırma oluyo neden olur bu sıkıntı
selamlar. Hocam bu parçalardan kullanıyor musunuz ? Kimden ve ne kadar fiyat aldınız bilgi verir misiniz ?
We are manufacturer of Hot Melt Glue Machine,if you have needs ,please fell free to contact with us :)
whatsapp:+86 131 64576609
Hello,we are manufacturer of hot melt glue machine,if you have needs ,please contact with us.
whatspp:+ 85 131 6457 6609
@@hurtyup Neden türkiyede bu tür nozzle lar üretiliyor mu ki?
good improved system.....
Hello,we are manufacturer of hot melt glue machine,if you have needs ,please contact with us.
whatspp:+ 85 131 6457 6609