@@Toolness1 Most likely will just keep it as a display piece since semi auto mods are too unreliable and not worth it in my opinion. Just a cool Cold War piece
@@Airsoftplayer555 I did a semi auto closed bolt conversion on one of these kits. It really wasn't bad, just basically did what PA did for the PM63C. Runs perfect in 9x18. I'd imagine the common .380 conversion would be pretty unreliable though.
@@ianloughney9570 Has anyone documented such a build? The kits are so cheap that I might make this my first build. I have to learn to weld...and buy a jig. The finished guns are $1k, which I'm just not sure I want to pay. Are those guns also rewelds?
Hello, would You be able to measure the length of the slide, I'm going to print a 3D mp-63 model but I need to pre-scale at least 1 part, of course if you could find a moment I would be grateful ;) .
The slide is exactly 10.5 inches from the rear of the slide to the edge at the front sight. From the very rear of the slide to the front of the lower "dust cover" area that sticks out is 12.935 inches as best as I can measure. Hope that helps!
Just got mine and wow these were demilled very cleanly. They make for a nice display. For $200 you cant go wrong even OG barrel!
Yeah they did a good job cutting them. Wat are your plans for putting it together?
@@Toolness1 Most likely will just keep it as a display piece since semi auto mods are too unreliable and not worth it in my opinion. Just a cool Cold War piece
@@Airsoftplayer555 I did a semi auto closed bolt conversion on one of these kits. It really wasn't bad, just basically did what PA did for the PM63C. Runs perfect in 9x18. I'd imagine the common .380 conversion would be pretty unreliable though.
.380 runs flawless in Semi and FA@@ianloughney9570
@@ianloughney9570 Has anyone documented such a build? The kits are so cheap that I might make this my first build. I have to learn to weld...and buy a jig. The finished guns are $1k, which I'm just not sure I want to pay. Are those guns also rewelds?
Hello, would You be able to measure the length of the slide, I'm going to print a 3D mp-63 model but I need to pre-scale at least 1 part, of course if you could find a moment I would be grateful ;) .
The slide is exactly 10.5 inches from the rear of the slide to the edge at the front sight. From the very rear of the slide to the front of the lower "dust cover" area that sticks out is 12.935 inches as best as I can measure. Hope that helps!
I just got one and Im missing three parts. Recoil spring and inside rod and one more piece I dont know what it is.
Thanks, you are supporting my addiction 😭
Welcome to the party, pal!
Epoxy putty instead of weld. A little model paint ..then it'd hang up real nice a heat gun would remove it
That's a good idea, I'll give it a shot.
ok
ok
ok
Hot glue gun