BMW e90 Rear shock mounting kit replacement DIY
HTML-код
- Опубликовано: 15 дек 2024
- I had to replace my rear shock mounting kit for the driver side. This video shows briefly what has to be done. Less than 1 hour of DIY which requires basic mechanic skills
Good job, thanks bud, mine went through today, i hit a pothole doing 70, heard a massive bang, pulled over to have a look about, all seemed ok until i drove away, then the knocking started and backend was all over the place. Ordered new parts will fit when get here
Great video....mine did it yesterday...a COMPLETE list of what is needed would have been super helpful.
Top strut Mounting
Fcp has a great kit
I don’t know the parts, got them from a store by spraying pictures.
Top strut mounting repair kit, if the absorbers are any way worn then replace these also as you will be effectively removing them to replace the top mounts, also replace the bottom mount, no point replacing all these parts without replacing the bump stop/dust kit
Finally found the video I was looking for. Going to fix my BME 328i broken mount issue tomorrow.
Best of luck! It is rather easy
Thanks. I was so lost when I was fixing my shock absorber
very helpful video!
@@danigames6096 glad it helped you
Gteat. Thank you. Have the same problem, but on the right.
👍👍
At 1:04 right under the top mount, there is like a flanged part that's rusted. Is that the part that broke from the metal cap? If so, did you remove it because I didn't see it again in the video. Also, is it necessary to change the shocks too because I had mine done less than 4 years ago...
You can just replace the rusted part, not necessary to replace the shock.
That all foam material upper/middle and dust cover..i replaced modified with black rubber..no more weak soft foam... more realiable....
and that shock dust cover is that supposed to be able to move up and down?
No, it sits on top. You could tape it, it protects against dust and mud going in
Hi sir...after replacement upper and lower mounting do we need to do tire allignment?
No you don’t need to.
Many thanks…
Hey question what tool did you use to get the bolt off ?
The top one? I think a 10 mm maybe smaller socket + a wrench (i used an adjustable one) to lock it. The bottom one was just a Bolt and I had to lock it with a wrench
what’s the parts called that i have to buy? i search but nothing comes up for my car🤦🏽♀️ i have a 2010 323i
Strut mounting kit
Its called this knots
Did mine yesterday but the top bit wouldn’t come through e ouch for je to screw the bolt on didn’t seem like there was enough thread to catch it tried pushing it up any ideas?
Put a bunch of weight in the trunk, that should squat it down a bit.
You need to use a jack under the rotor and push it up!
Strut mount kit. www.amazon.ca/KYB-SM5752-Strut-Mount-Kit/dp/B01GQ8D60A/ref=asc_df_B01GQ8D60A/?tag=googlemobshop-20&linkCode=df0&hvadid=292997173836&hvpos=&hvnetw=g&hvrand=13779184375353663863&hvpone=&hvptwo=&hvqmt=&hvdev=m&hvdvcmdl=&hvlocint=&hvlocphy=9000812&hvtargid=pla-587941011581&psc=1&mcid=38b7477c78413d66bd4b2804ab847601