Cat Back Exhaust vs Full System Comparison
HTML-код
- Опубликовано: 1 ноя 2017
- Description Comparison between Xforce 2.5" Stainless steel cat back exhaust and full exhaust system with Xforce Stainless steel headers 1"3/4 Primary 3.0" secondary with 3.0' hi-flow cats.
Thank you sir for going to the effort to make this video. I’m tossing up cat back or full and you just sold me on a full 👍🏻
Nice ssv 👍
Any drone mate? Particularly when cruising at the 110 - 120km/h mark?
No annoying drone..being a ute the cab is insulated from drone.. it has a nice deep rumble when crusing.
Hey does this have centre hotdog or centre muffler?
muffler
Does the full exhaust still have the original Xforce 2.5"?
yes
@@nofaze Thanks! Got the same 2.5" on my car right now, getting headers and high flow cats done soon.
is the car tunned, cammed or any aftermarket parts apart from the exhaust?
When this video was uploaded the ute had not been tuned or had any aftermarket parts installed that would've influence the note of the exhaust... It's since been tuned and had an OTR install.
What about performance differences??
D Howison: Holden claim the LS2 has 270kw of power and 530Nm of torque, but for a ute the big challenge is getting all that power to the ground through the rear wheels. After the installation the dyno results were 257kw & 488Nm so well under. I then had it tuned along with an OTR installed and got 284kw & 527Nm. So a slight improvement but a noticeable one.
So less performance with upgrade over stock?
Rhino are too scared to leave the public comments open on their video.
We