Modifications to a low cost mill vice

Strip down and clean then make some changes to correct problems and improve lubrication
Enots / @enotsengineering

[@priority2]

Great tutorial and you’re a great teacher. Subscribed!👍😊

[@eyuptony]

I have a couple of these vices. Looks like a well worth job to do to make them last longer. Thanks Tony

[@bostedtap8399]

Nice modification.
Thanks for sharing.

[@metalmanglingmariner]

Looking good so far. Eaiting for ep. 2.

[@flashgordon6238]

Oil is far better than grease for a vise - it doesn't attract chips like grease, plus its a whole lot easier to clean off.

[@pgs8597]

G’day Alan, it’s looking good so far, see you in the next episode.
Cheers
Peter

[@mickellis8747]

I have the same vise. Check if the jaws are level with the bed, I bet they aren't. I found the top jaw surface where the movable jaw rides was not parallel to the rotating base by .007".

[@rickox12]

Interesting I've got the same vice might inspect mine aswell

[@QBlackDeathQ]

bit disappointed this ended so soon :/ great video

[@paulrhodes6975]

Nice job.

[@donmittlestaedt1117]

Thank you

[@thedude4632]

Vice name where it’s available

[@enotsengineering]

Hi Meredith I purchased the vice from Chester machine tools UK

[@kslats916]

Where did you buy this vice?

[@enotsengineering]

The vice was supplied by Chester machine tools