Mercruiser mercury upper unit FULL rebuild - EVERYTHING
HTML-код
- Опубликовано: 20 ноя 2021
- Deep dive into new Yoke shaft design with 3rd machine cut
• 3rd O-ring groove on M...
If interested in purchasing these products, visit our Amazon Affiliate links below, I earn from qualifying purchases.
1. GLM oil seal kit (87500)
amzn.to/3njQWrT
2. Gasket compound sealant (1525607)
amzn.to/3DcrJ8c
3. Old seal punch tool (89-101-19)
4. Water pocket cover
amzn.to/3UWkIDO
5. Loctite 680
amzn.to/3wG0VKW
6. Spanner wrench
amzn.to/31GwUiD
7. Inch pound torque wrench
amzn.to/3G1aDLl
Thanks!
Deep dive into new Yoke shaft design with 3rd machine cut
I cannot thank you enough for all these videos. I have watched these over and over. Currently rebuilding a 1988 Alpha One, Gen 1 myself. Never had one before only outboards. I will say you make it look easy! Your videos go way faster than my actual work! Thank you for your time, trouble and efforts and attention to details.
The quality and attention to detail is excellent. Keep 'em coming. Thank you.
Thank you, my brother, for this distinguished work. I salute you, my brother❤❤❤❤❤
I'm only 10min in and you are doing a GREAT JOB!! 👍
Putting oil on the seal when installing is a far better idea than water.
Thank you for such a great video!!
Very thorough, and explanation.
Really nice detail 👍😁
Fantastic video!
Can you do a series of videos like this for the gen 1 lower unit?
Great video and explanation, congratulations on a great job done.
do you happen to have a full parts list or a kit number? My upper gears are totally eaten and I will need to do a complete rebuild.
Mike could you please give the part no. for the preload washer that you do not use again on the upper unit gear drive? thanks so much,
I use the same material for sanding. Mines 800 grit paint scotch. Works best with WD-40.
OMG if you could do one with Bravos...Good work here.
Is it possible to press that upper carrier bushing on the vertical shaft, at home?
Hello, i was wondering why you didn't do all the shimming procedure with shimming tools. I'm going to change the 2 roller bearings and i need to know more about.
Hi Michael, great videos it appears my lower seal has identical sides? Spring on both sides, so apparently you can install either side..
hey @DIYwithMichaelBorders should there be play in and out. Like I can push the driveshaft against the gears and pull it out about 1/4 in when I turn the driveshaft and u-joints. I just took the outdrive off my boat because I was looking to see where I had a gear oil leak. There was gear oil in my bellow.