It was a helpful video but I wish you had one that showed the process on a new door (without any existing holes) so I could see all the steps including how to make the hole that the deadbolt goes into in the door frame. :)
I encountered the same problem with half drilled hole when installing new door knobs and dead bolts. The push bolt 1" hole was okay did not require re-drilling. As you suggested I purchased the Roybi door hole drilling jig to re-drill the four large holes. The jig worked extremely well I was able to easily re-drill the four holes. Thanks for the great video.
Very informative video, and great instruction for using the Lenox tool, which is why I searched for this. One question. This metal door is hollow. Won't the metal buckle when tightening the screws on the deadbolt? Seems like either the metal will squeeze and buckle, OR the deadbolt won't be supported properly due to inadequate torque on the screws. Thanks.
Literally this is exactly what I needed. Thanks algorithm and Facebook 😆
Haha, so glad to hear that! 😂 The algorithm strikes again!
It was a helpful video but I wish you had one that showed the process on a new door (without any existing holes) so I could see all the steps including how to make the hole that the deadbolt goes into in the door frame. :)
I encountered the same problem with half drilled hole when installing new door knobs and dead bolts. The push bolt 1" hole was okay did not require re-drilling. As you suggested I purchased the Roybi door hole drilling jig to re-drill the four large holes. The jig worked extremely well I was able to easily re-drill the four holes. Thanks for the great video.
You’re very welcome! Thanks for watching and for the support!
Thank you.
Thanks so much! You gave me all the confidence I needed to use my jig correctly. Great video! Keep em coming.
Thank you for making this video. Fast tracked my understanding on how to use it!
Just what I needed as well! Many thanks!
You’re very welcome! Thanks for commenting!
Very informative video, and great instruction for using the Lenox tool, which is why I searched for this. One question. This metal door is hollow. Won't the metal buckle when tightening the screws on the deadbolt? Seems like either the metal will squeeze and buckle, OR the deadbolt won't be supported properly due to inadequate torque on the screws. Thanks.
Saved me, thanks man!
You’re very welcome! Glad you found the video helpful!
Does this jig tell you where to cut out the strike plate on the door jam? Literally no video on RUclips highlighting this product address this.
It heated up because you were aiming the holesaw down.
sponsored by Lenox? :P
Haha! Coming soon maybe? 🧐 Wouldn’t mind a Lenox sponsorship at all!
They want you to buy a new one every time lol they know it's going to melt