Making progress. Not sure about the dent by the hand brake. Use your shrinker to get the edge profile. It is amazing how much you can shrink and produce that profile.
Looking good! If you get a big chunk of copper clamped behind those thin welds it'll be a lot less likely to burn through. Not sure if that is what you were talking about with a heat sink.
![Chris Langan - The Interview THEY Didn't Want You To See - CTMU [Full Version; Timestamps]](/img/1.gif)
Making progress. Not sure about the dent by the hand brake. Use your shrinker to get the edge profile. It is amazing how much you can shrink and produce that profile.
I will be there soon just keep hollering at the videos I’ll learn
Looking good! If you get a big chunk of copper clamped behind those thin welds it'll be a lot less likely to burn through. Not sure if that is what you were talking about with a heat sink.
Thx, I was trying that, I think I need to go a little higher to get to thicker metal to tie in to…
I have the same repair to do... hang in there and keep plugging, or seaming, or butting, whatever it takes ;-)
Yep I am back in, so be prepared for slow and painful videos….😂
@@pucman1 i have made many so know them when i see them 😎
I like the way you fill the holes…. It’s nice
I try what can I say, didn’t blow it up though
ya I my tunnel is up in the attic I have been ignoring it and I know I have welding to do on it also.
Jump on in there Mike when you can
Yeah, I don’t think that dent is normal…
Thx … you would probably know! 😂