This nor the Installation piciture book BL Series Installation Instructions tell exactly how far out to install the two Wall Profile verticle are to be from the back corner of the wet wall in order to get the shower enclosure perfectly square. That is a key measurement that should be witht he instructions. I know it will be ROUGHLY 36 inches, but that should be established in the guidance on RUclips and in the installation instructions.
Anyone else have a sag that doesn’t allow the bottom part of the magnets to come together to form a tight seal? If I press the top frame up toward the ceiling, it will seal properly. But it won’t on its own. I don’t know how I should adjust the set screws on the sides to alleviate the problem. Any suggestions/ideas welcome.
At what measurement do you put the wall rails at. That’s really needed to start. Is it 34” to center or edge???? Come on the first step is missing. Really
This nor the Installation piciture book BL Series Installation Instructions tell exactly how far out to install the two Wall Profile verticle are to be from the back corner of the wet wall in order to get the shower enclosure perfectly square. That is a key measurement that should be witht he instructions. I know it will be ROUGHLY 36 inches, but that should be established in the guidance on RUclips and in the installation instructions.
Do you have a video on a semi frameless shower install? With a shower screen on one side and pivot door on the other? Say 1200 x 900
Is there a link to the instruction manual? Ours did not come with one
I have a 34 x 34 corner shower, how far from the corner of the wall do you place the wall profile?
John
Its the external measurement. so for your size it 34 from the wall to the external part of the wall profile
Missing pieces!!! S10 and S06. Who should I call?
Anyone else have a sag that doesn’t allow the bottom part of the magnets to come together to form a tight seal? If I press the top frame up toward the ceiling, it will seal properly. But it won’t on its own. I don’t know how I should adjust the set screws on the sides to alleviate the problem. Any suggestions/ideas welcome.
At what measurement do you put the wall rails at. That’s really needed to start. Is it 34” to center or edge???? Come on the first step is missing. Really
bluetooth drain ? 😄😂😂