If you only have one mic, in my case a sonarworks reference ID RTA mic, would you suggest tuning my left right by just tuning one side (having mic as close to the speaker as possible and running pink through just that one speaker) and then copying and pasting the eq to both sides or would it beneficial to run pink through both while being center to the two? Or would that create comb filtering?
Group delay allows you to see frequencies that are interfered with by reflections. You should not touch the EQ on any frequencies that are raised or lowered.
Thanks for the video! I feel like a voiceover or more in-depth notes would be helpful!
If you only have one mic, in my case a sonarworks reference ID RTA mic, would you suggest tuning my left right by just tuning one side (having mic as close to the speaker as possible and running pink through just that one speaker) and then copying and pasting the eq to both sides or would it beneficial to run pink through both while being center to the two? Or would that create comb filtering?
Hello brian malota ^^ ~I measure on one axis (right speaker), copy the EQ and paste it (left speaker).
Hello sir, great video. Please i want to ask how you placed the four microphones in the room.
Thank you
Thank you.... Speaker 2m from the front. 4m. 6m. 8m. The height is 1.2m.
Thanks for the reply. But were they All on axis or some were off axis of the speaker.
Located on the speaker axis
@@kor3321 thanks sir much appreciated
The speaker configuration is 1+2 on top, 3+4 speakers on the bottom, and 5+6 speakers.
Nice video! Can you please elaborate what are you looking for exactly on 9.20 using group delay function?
Group delay allows you to see frequencies that are interfered with by reflections. You should not touch the EQ on any frequencies that are raised or lowered.
@@kor3321is this why you didn’t address that peak around 1.7kHz, because it was showing as flat with Group Delay?
1.7khz is the crossover point. So I didn't use IIR Eq.
@@kor3321 ahh. Does that mean you ended up adjusting with an FIR filter?
no. The video is IIR DSP. I will prepare a video unsing FIR in the next video
where can I get the sub and top lines? "My large trace" top, low, sub+top.trf can you give me a link where to download it?
Hello Tony.... The top and sub target traces in the video were created using my IIR DSP.
What are you using for the loop back to find IR
The interface uses octacapture and is connected to in 8 and out 8.
Nice. Where can I get that target trace? Thanks
My target trace was created by myself in IIR DSP(Eq)
Can you please send me target trace file
What system processor do you use?
It’s ArmoniaPlus system design, from powersoft. I think so.
Yes, it's ArmoniaPlus system design, and I use it with Quad matched mic
@@kor3321this would be with PowerSoft amps, right?
share your targets)
안녕 친구…타켓 트레이스는 사람의 기준이 다름니다 소리를 듣고 DSP에서 스스로 만들어야되고 소리를 듣고 본인의 판단해야됩니다 그리고 중요한건 smaart 는 도구입니다 판단은 당신의 능력입니다^^~