Ooni Koda 16 Natural Gas Conversion Step By Step Tutorial
HTML-код
- Опубликовано: 13 сен 2024
- Detailed instructions on how to install your Natural Gas Conversion Kit on your Ooni Koda 16
I highly recommend this IR gun. It will get up to pizza oven temps: bit.ly/4b93rxd
Check out other great thermometers from Thermoworks: bit.ly/3Sh5yWW
Pizza Gadgets I Recommend:
Infrared Thermometer: amzn.to/3zP4HUN
Gozney Perforated Peel: amzn.to/3Ksfj0L
Ooni Perforated Peel: amzn.to/3MBy1G1
Budget Friendly Perforated Peel: amzn.to/3ZWfiYF
Wooden Peel: amzn.to/40U5mQM
Metal Peel: amzn.to/3MwWH2m
Gadgets I recommend:
Metal Spatula: amzn.to/43gatvY
Rubber Spatula: amzn.to/3Un516x
Whisk: amzn.to/3KH5w8o
Bench Scraper: amzn.to/3KH5BZK
can you do a conversion video for the Gozney dome propane to natural gas please.. in Canada they only sell propane
How long is the hose the ooni gives you ?
Great video 👌
Thanks 👍
Well done
Thanks
My ooni rocks on nat gas. 900 in the hot corner in 15 min. I can make pizzas all night!
I followed this vid and after firing up my temp isn’t going above 600F after 40 min. There is a slight wind out and 45F outside today.
Can my flame be too low or my gas flow valve need to be loosed somewhere?
That doesn't seem right. I just fired mine up the other day when it was 33 degrees out. It got up to 900 in 22 minutes. You should contact support
When I did this I didn't realize I wouldn't be able to easily switch back to propane. Unless you know you will 100% use the oven near the gas source I would think twice about going this route.
100% agree. The screws you need to take off to access the panel for swapping, tend to strip very easily. after swapping mine back a forth a few times, most of the screw holes were stripped.
Sorry to hear that. Good to know.