Mount a clamp on back of axe head tight but with no damage to axe head with drilling. Then drill threaded hole in clamp just back of axe heal. Then thread a eye bolt in threaded hole of clamp. When sharp just remove clamp. Using clamp makes your system work on any axe head without damage of drilling.
The problem with the strop is that it is soft and actually rounds off the end, it breaks off the wire which is good. Take a softwood scap of wood and put some metal polish on it and use that, keep polishing until you start shaving fine ribbons off the wood. The hatchet is good for felling or carpentry but using it for limbing would damage the fine edge you put on it. You could also use a magnet instead of drilling a hole in it.
Mount a clamp on back of axe head tight but with no damage to axe head with drilling. Then drill threaded hole in clamp just back of axe heal. Then thread a eye bolt in threaded hole of clamp. When sharp just remove clamp. Using clamp makes your system work on any axe head without damage of drilling.
Thanks bro
I was thinking a very strong magnet to hold the eye, I like the clamp idea too.
The problem with the strop is that it is soft and actually rounds off the end, it breaks off the wire which is good. Take a softwood scap of wood and put some metal polish on it and use that, keep polishing until you start shaving fine ribbons off the wood. The hatchet is good for felling or carpentry but using it for limbing would damage the fine edge you put on it. You could also use a magnet instead of drilling a hole in it.
Thanks man
I'll just stick with my grandmother's sandstone grinding wheel.
Fajny pomysł, tylko po co wiercić ten otwór? Nie lepiej magnes? Np. neodym?
Сколько проблем создал чтоб топор наточить
Бумагу- то он режет, но... Будет ли так с деревом?????
Großartige Idee!
Thank you for supporting the channel
I don't use an axe for cutting paper! You didn't either, a 30° angle I think would be better for an axe.
Existen las piedras de afilar lijas etc etc es una pavada
It didn't look like the stone was wet
А рубить как? При таком угле заточки топор будет вязнуть в дереве не расщепляя его. Нож должен резать, топор - рубить!
Thank you for your feedback
Why so sharp? If you use that as an axe it will go blunt very quickly.
Axe heads use a rounded shoulder because of that.
Or are you a ninja? 😂
Thank . you adjust the height of the screw
@@tipsintelligent2605 no matter what height you set it still wont produce a rounded shoulder, Axes should have that