HOW TO... FILL & TEST UNDERFLOOR HEATING

A 'How To' video on how to install underfloor heating. This is only a quick video and doesn't show you everything but showcases how to get it in the ground, fill it up and test it properly - which often gets overlooked.
As always any questions, please do leave a comment.
Powered Now is the #1 app for trades created to help you save money and win more work. Click below for a free trial:
www.powerednow.com/free-trial...
#glisterservices #heatingengineer #plumber #underfloorheating #howto

[@Zaine22]

Little tip when doing underfloor heating do a big loop little loop system or snail it in then back out on its self as you Will heat the area up evenly. The way that has been done you are going to heat the room up left to right let's say. Also sleeve the connecting lengths to the start of the circuit that goes into different rooms are to a different area of the building to reduce the heat output as that now is uncontrollable heat which means if you want heating at the opposite site off the building from the manifold the connecting lengths are going to give of heat in a different area

[@deakgolf20]

Where did you get this manifold and pump setup from Todd?

[@sergiofernandez3725]

Good stuff Todd. Do you add Inhibitor or is it not needed due to the plastic pipe?

[@glisterservices]

You would normally biocide to UFH or when i’ve normally finished i will fill with demineralised water, but in this case it is just normal mains water, to get it filled and tested so the screed can be laid